Dewhel Lift pads Jack Pad Billet Anodized Red Aluminum Floor Jack bolt on Jack Points For 6th gen Camaro 16-18,except convertable

I bought these in red, to aid with visibility when looking for them under the car. These Dewhell lift pads have a very good build (fit and finish); however, it would be nice if the seller stated the type of aluminum used. These may seem expensive, but the blocks are beefy - think of a blank AR lower - and it is slightly less weight for each.The challenge you will encounter is installing them. Not because they are hard to install, but because most folks don't have a ramp to put the car up first. Assuming you have a ramp (race-ramps, pieces of wood, or other), the installation is no more than placing the pads on the pinch welds and tightening the two Allen screws on each. A bit of blue Loc-Tite should be considered.For the 6th gen Camaro, these go on the lift locations. There are three apparent locations on each side (pinch welds) of the car (two in the front -back to back, and one in the rear). The best place to install these in the front is on the forward mount and on the rear there is only one location.The con is that these have a non-flat bottom, so you need to be careful in how you lift the car. I learned from Camaro6 forum members and recommend to add 3M tape to the bottom to reduces the risk of slip.Can you do the same with slotted hockey pucks? Yes. But IMO this kit is a much better solution that clearly helps with identifying the proper lifting locations on the car.

These are great--and the little red accents peeking out from the black ground effects of my SS Convertible are sweet. Yes, I got them for my convertible. I waited a year for the convertible-specific ones to come out, but they didn't. Someone online is selling what looks like the same product with one "ledge" machined down for twice the price. It's pretty close to fitting, I filed it down a bit to make sure the bolts had a solid grip.The targets are easy to see when lifting and save the lift points from damage.

The media could not be loaded. A must have if you have a 6GEN Camaro or any vehicle with pinch welds!! These beauties will save you the heartache of damaging your vehicles under carriage and structure. Again before you put a jack under your 6th GEN in my case, make this purchase. This product is honestly worth more than it is for. It is a definite INSURANCE POLICY! They are the exact same product as the higher priced ones but without the logo. Purchased on Amazon, received the following day, packaged very nicely, billet aluminum, I chose red, quality product! Total game changer and quite frankly I don’t understand why GM does not include these or build their their vehicles with them. Chevy dealer loves them, though they use a lift. Dealer mechanic even took pictures to show other Gen6 owners! A must have! Quality product that is very understated! Camaro_2sswhite_ghost

I have used these several times. They work as detailed. Add thread locker to the set screws. Not hard to install. I use for jack stand placement. There are 6 lift points under the car but these are sold only as 4. Sold in pairs or as 6 would have been better for me. If putting each on a jack stand only 4 means you will jack the car where there is none.With the factory side skirts on a (1LE model) they are tricky to access with a jack. These would work much better if they were a little taller (5/8").

I LOOK INTO YOUR PRODUCT YOU CARRY

On time delivery. Good quality and fit as advertised

Install is easy with a generous gouge in the aluminum and some threaded set screws.They allow you to raise the car via the subframe over the pinch weld rather than the weld itself as advertised.Helps reduce damage from lack of attention to detail. Should make a lift operators life easier too.Have had the car in the air in both sides now.

The build quality is nice. Solid aluminum. They are smaller than I was expecting but they get the job done. I used some blue thread locker on the set screws. Just for piece of mind. Been riding around with em under my car for about a month and used em to jack the car up once. They'll hold up for a long time. Happy with the purchase.