Plastic Welder, 25ml

This product is intended for repairing plastics as the label indicates. Remember that some plastics are difficult if not impossible to repair. This item is not an "epoxy" but rather an acrylic adhesive (I think.) I have used it in the past with great success for repairing cracks in the floor of a shower insert. I have also used it for "casting" a new plastic bushing housing for the tub of an old electric dryer. This stuff is somewhat stronger than most epoxy adhesives and will actually work on a fairly wide range of materials. Remember that all areas to be repaired need to be clean and roughened a bit if possible.As others have noted, the working time is very short, the fumes are nasty (use adequate ventilation), and the shelf life once opened is only a few months at best.

I have used this product many times before. It is much better than epoxy on plastic. When i just opened the tube 5 days after my return window closed, since you only open these dispensers when you need them, i discovered one side was 1/2 empty. I guess the vendor got a bad run. Now I'm SOL.

I searched for quite some time to find reviews for an inexpensive polymer epoxy for a pistol frame, and finally rolled the dice on this brand. The project was for a MagWell that I was installing, which recommended epoxy adhesion for the best durability.Read the label, prepped the surfaces, bonded the parts and hoped for the best. To my surprise it held firm and touched up nicely. So far so good with the durability as it has held together just fine after months of use. If any issues are discovered, I will post them here.Note: Keep in mind the the color is an off-white, so color matching may be necessary.

I got this to glue some plastic parts of my motorcycle and, well, it didn't stick. The waiting time, 5-10 minutes, is better than gorilla glue, which is nice, but I probably spent half of it trying to push out an equal amount of the two substances.I recommend getting a knife and cutting the part of it that you push so that you can control how much of each substance you push out. Seriously, I wasted most of it trying to get less white stuff out and more transparent yellow stuff.

Fixed my broken automobile electric rear view mirror motor mounting bracket. The bracket inside my exterior rear view mirror was broken and other epoxies did not bond. This saved considerable money and labor that would have been required if I replaced the motor (removal of door interior panel and other interior panels due to extensive electrical cabling). I recommend this product for plastics repair; saved a bounch of money for a small part.by mwindow

Material may have been old , but couldn't get it to come out of tubes was too thick. Ended up punching holes into tubes was still difficult to mix.

I have been looking for plastic epoxy to "weld" detatched laptop hinge from cover. This did the job so it is like new. I highly recommend this epoxy if you're looking for some strong epoxy made for plastics.

3 of the 4 carded tubes I bought had hardened in the tube and went straight into the garbage, the one that was useable didn't work on 2 different types of plastic. The plastic pieces came apart the first time I used them. Does not work as advertised.