CarBoleMicro Electric Gasoline Fuel Pump Universal 5/16 inch Inlet and Outlet 12V 1-2A 35GPH 4-7 P.S.I.

Used to siphon old gas out of my boat. Worked great!

What this was installed on is a 1984 Dodge ram pick up with a 360 V8. I originally purchased a Carter fuel pump from Amazon and it was complete junk. They advertised a curved arm which is what I need however what came was a straight arm I checked the part number and verified they sent the right part. However due to the fact that it was straight the camshaft was not able to push down the pump enough to pump fuel. It was the complete wrong design of fuel pump once again more Chinese garbage made by Carter. I purchased this fuel pump as a last resort option to get the truck running again wired it up blocked off the original pump re-ran the fuel lines and now it works flawlessly. If you have an old vehicle that has a carburetor this is a must to replace the factory pump. However you will have to run a Fuel pressure regulator due to the fact that this pump pump entirely way too much fuel he needs to be turned down to around five psi this is roughly 7 to 10 psi which is too much for a carburetor. But other than that this fuel pump works great

Works great, easy hook up!

This pump is made with a steel shell for the pump and the filter and steel hose barb, which makes it unsuitable for use with gasoline available in the USA because it It will rust through and fail. The pump arrived filled with a mix of kerosene and light oil to prevent it from rusting and seizing in storage before it can be installed. Find a pump that has a brass shell instead. Fuels that contain ethanol always contain some water. Ethanol is extremely hydroscopic, the only the question is how much water. Unfortunately, for the steel shell, it really doesn't matter how much, any water will promote rapid corrosion. If its installed below the tank level, fuel will leak even when the pump is off.My particular pump arrived minus one of the hose barbs, I had to take a barb from the 30 year old die cast pump it would have been replacing and I noticed that the old nipple was brass, and the new one was steel, which was easily remedied by taking both barbs from the old pump. Then I grew suspicious and tested the shell with a magnet and I realized the manufacturer hadn't simply plugged it up with fluid leftover from testing, this pump has a steel shell that corrodes easily and is suitable for use in most of the world but not the USA because it isn't suitable for use with fuels containing ethanol.I'll be sending mine back. I suggest you do the same if you can.Update:Needed the boat's tank pumped out and adjusting the 40 year old mechanical contact solenoid pump was more frustrating than usual (failing springs), so I used this one for pumping out the boat after all, and it can't be returned once its been used and has fuel in it. The fuel delivery rate was around 1/3 of that of the pump from the 1970's, right around 11GPH with a 24" vertical lift and 5 feet of 5/16" ID tube on inlet and outlet. That makes pumping a 20 gallon boat tank into 5 gallon jugs a tedious chore. To be fair its also a lot smaller and lighter and the old one was $23 in '78 so its also far less expensive. The 1970's pump is a cast aluminum shell and pump structure with brass hose barbs and doesn't suffer from water in the fuel. Its completely repairable so i'll fill this new one with oil so it doesn't rust inside and put it on the shelf until I can give it to someone who needs one to transfer fuel.

Worked great on 1980 C 10 pick up truck

I had a failure with the first pump BUT Carbole people were great and sent me a replacement pump and it works GREAT!!!! Thank you for a quick replacement!!!!!!

It worked ok just not enough pressure for my carburetor so I am going to use it as a transfer pump for fuel well after the company contacted me about this pump not working properly I explained what the pump was actually doing and that I decided to keep the pump to use as a transfer pump because the pressure was so low they offered me a refund for half of the price of the pump which I thought was pretty amazing great people to do business with we need more people like this today in business and I will do business with them again

It was good for 3 years and I only put 1000 to 1500 miles a year on my vintage GTO, then it just quit- still voltage to it but not working. Fortunately it died just after I drove into my driveway but would NOT buy it again as longevity is terrible- if you do buy, order a second one to keep in your trunk so you won’t get stranded!