Adjustable Satellite Dish Antenna Mount for Roof or Wall Installation, TV Antenna Mast, J Pole Mounting Bracket Weatherproof, Hardware Included

I very much like this product, it even came with lag bolts. In fact I didn't see any downsides to it. It was easy to set up and can be used as a wall mount or a roof mount.

Ok StarLink owners, this is what you are looking for. I have a steep roof and there was no way to keep Dishy mounted less than 40 degrees from the vertical using the mounts available from Amazon. I was able to keep the dish plumb and level with this adjustable mount. The only modification I had to make was how it attaches: simply take a 3/8” metal drill bit, put the dish into the pipe, drill through both pipes, and then slip a 3/8” x 2-1/2” full thread galvanized bolt through. Tighten up with a washer and nut so it is rock solid. Then I had a roofer use the lag screws and flashing tape that was provided with the Starlink roof mount. He fed the wire down my downspout, plugged it in, and no more Dishy lawn ornament!

I have an FTA dish that is having some difficulty staying put. I'm hoping that the use of this three leg mount will help to hold the dish in place better, especially during high winds. My original setup is also troublesome in that it gets out of level, again hoping this will work to resolve that problem. At the least it'll be easier to adjust it back to where it needs to be if it does get out of alignment. The unit appears strong and though smaller than I expected, it says it's designed to handle a dish the size I have. For the price, it can't be beat.

Glad I read the other reviews for this as the width is not 2 inches. Worked perfectly for what I needed it for though. 1 1/4 galvanized pipe fits perfectly into this mount and starlink gen 2 (square dish) fits almost perfectly into 1 1/4 pipe. Just had to put a small set screw through pipe into dish mast to keep it from possibly spinning. The mount is very sturdy and seems well built.

Used this to install a Starlink dish. Used some plastic conduit to shim it together and recreate the factory Starlink fitting. Would have saved time and money to just buy the factory mount. Good mount tho.

Bought this mount a Starlink dish on the side of the house, oppose to drilling into the roof. Quality is “ok” not terrible, but my issue was the support arms, which where just a hair too short to mount at a 45 degree angle. If you wall is straight up and down, it will disappoint.

I used it to install a tv antenna on a sloped roof and it worked fine.

Cables Direct Online Universal Outdoor Heavy Duty 2 Inches""""""""""""""""The pole is not 2". it is 1.5 at best yet very sturdy. I did notice others mentioned in their reviews that the pole is not 2". I recommend!