LE LEMATECDigital Air Pressure Regulator, 1/4-Inch NPT Diaphragm Airflow Valve Up to 160 PSI Digital Gauge for HVLP Spray Paint Gun, Sand Blaster & Other Pneumatic Tools (DAR02B)

I love it! I use it with my airbrush and it works great. The only issue I found was there is no way to mount it by itself. You would have to fabricate at bracket or use a u bracket. However, because I use two airbrushes, I have a three way splitter installed above the regulator that had screw holes that I used to mount it to the side of the table so I can adjust the air pressure at will. I love the way I can dial in the best pressure to get as fine a line that I need.

I decided on a digital guage on my LPH400 because the analog guages are hard to read a lower pressures. My Iwata likes 8-14psi for metallics. The guage is really easy to use. I didn't have to change any of the settings. It reads in psi as is but you can change it if you want. Just turn it on, set it, and spray. The guage turns off after a few seconds. It maintains the pressure well @ +/- .5psi. Good enough for the girls I date👍

Using a tire gauge on each tire four or five times to get the proper pressure was a pain, if I could find the tire gauge. Using this regulator, it’s as easy as setting the pressure and then letting the regulator do the work.

have to play with air inlet on gun as well to get desired psi. Not bad I like it

Unfortunately I waited too long to use this regulator, over the 30 day return period. It would never adjust properly, kept bleeding off the pressure after setting, followed the instructions and it never would adjust properly. Going back to analog regulator, this thing is garbage.

Was using this gauge and reg for relatively low flow instrument work. 5to90psi no problems. It’s small and compactthe digital gauge goes to sleep rather quickly otherwise no problem.

bought 2 units one worked fine. The second unit did not turn on. Suspected a dead battery. Instructions they provide for use does NOT include any info on how to open unit and replace battery. Had to go to Youtube to find out. Bought an new battery ($10.12) and installed it. Unit then worked. Seems their quality control department should add a final test BEFORE the product is shipped. Also for a bit $ more think they should include a male to female adapter on the air pressure input side so you don't have to go by one if you have a male snap in connector from your air hose.

Updated a 20± year old Air compressor. Plumbing, hose, and went to high flow connectors.Yes this gauge doesn't stay on, but who really needs it to stay? Very easy to set not guessing or having to look harder that needed.Very accurate due to have a Digital gauge for the tank itself.Broke the original Pressure switch by accident and had to modify the cover but overall no one would guess its a 20+ year old Air compressor unless they know compressors