5F1 Tweed Champ 60S Guitar Tube Amp Amplifier Kit Chassis DIY

You’re better off getting a mojotone or something like that.

Just a heads up for prospective builders, the color codes do not match any wiring schematics seen online.The power transformer is laid out with low voltage on one side and high voltage on the other, NOT in an input:output orientation.The GREEN 120v and BLACK 0v cables on the "low voltage" side of the power transformer connect to your power cable, fuse, and potentiometer (orientation does not matter). The "high voltage" yellow and blue wires are ONLY used to power your high voltage rectifier. Again, the black centre tap connects to ground.The ORANGE wire is a centre tap for your 6.3 volt filament, and this connects to ground.The unused red/brown wires from your low voltage side, and unused yellow or blue pair of wires (use yellow/yellow or blue/blue, not both) will be isolated with electical tape and cut or coiled off in the chassis. They will not be used in the circuit.If you are outside the US, the RED or BROWN wire on the "low voltage" side of the transformer will connect to your wall outlet INSTEAD of the green wire. The corresponding voltages are listed on the transformer.I wired mine point-to-point rather than utilizing the included turret board. Comes with all parts necessary to complete the amp. 10/10 experience would build again.

I need to print a new one. this will work and I won't be needing any thing else.