220mm x 220mm x 3mm Chamfer Borosilicate Glass Build Plate/Bed for MK2/MK2A,Wanhao Duplicator i3, Anet A8, Anet A6, MP Maker Select 3D Printer (220x220x3mm Chamfer)

It's my anet A6 perfectly. Little Hairspray or glue stick like always.

great upgrade for the print bed on my mini v2.

One atar down for adhesion. Bare or with hairspray doesnt work for crap. A thin layer of PVA glue and the stuff works great. Same with painters tape.

The media could not be loaded.  My prints with this glass and a little hairspray are mint in comparison to using painters tape or the original adhesion board. It’s worth the little money it’s cost.

Not Really sure how it happened, but after placing this on the printing bed, it made leveling impossible.... Spent about 4 or 5 hours trying to figure it out. I assumed the Y-Carriage was warped, so I ordered the upgraded model. After installing the Y-Carriage, leveling was still impossible. I took the glass off and placed it on my table and noticed one corner was higher than the others. Terrible

Just as it says. Mine doesn't seem to have any warping and it's worked well so far.

Came in a awesome package, no damage, it's a glass bed.

flat and smooth kaplon tape stick well

The media could not be loaded.  Pro: fits my MonoPrice maker select 2 perfectly!Con: doesn’t come with clips.Note: might want to adjust your gcode to allow the bed to heat first. And then your extruder.I found the glass takes a bit of time to come to temperature, so I use Octoprint to put in a little bit of a delay, but the same can be achieved in your Cura Slicer.I also increased my print bed temperature by 5 degrees and I am not using any heat paste.

Direct replacement for Monoprice mini select v2. Great adhesion for ABS and PLA. Straight and square and smooth edges. Few paper clips to secure the bed to the aluminum plate and it’s good to go! I like the thickness and it sets the screws down tight to level the bed and no need for a Z-spacer. Came packaged very well and secure.Rated 4 stars because it is a bit expensive for a small piece of glass but it does work well!

Fit my mini perfectly. had to lower the build plate screws but there was lots of room to do this. Now much easier to remove items after build. I wipe down with 70% Alcohol after build and do not use any glue or hair spray. Prints fine.

perfect fit for my printer table

A perfect surface for building big parts...now, if only you could buy conductive glass.