Pack of 4 RF U.FL(IPEX/IPX) Mini PCI to SMA Female Pigtail Antenna Wi-Fi Coaxial RG-178 Low Loss Cable (5.5 inches (14 cm))

I used a pair of these in the 4 inch length in a RPI4 based 4G/LTE access point. I needed to add a pair of external antennae to the device, and these were perfect for placing a pair of SMA connectors on the exterior of the case for attaching the antennae. Great quality construction, no cross talk or interference between the leads, and they look good too.

I used this to provide antenna connections for a LimeSDR Software Defined Radio board. This length is a little more than needed for putting it in a small box, so I'll probably order some shorter cables later. But, for now, it got me up and running.

The UFL pigtails were used to install an external antenna on a Sagemcom T-Mobile home internet router. The pigtails are long enough to reach outside of the router, but a couple of extra inches would come in handy. Overall very happy with these pigtails so far.

These work very well, but I didn't read (or pay attention) to the length, and in my installation I could have used another centimeter or two. They got the job done for me, but it took a couple of tries for me to get everything connected and stay connected while I reassembled.No attenuation that I could measure, and the connectors are very high quality.Would buy again.

GREAT product AMAZING customer service SUPERB communication and OUTSTANDING knowledgeI got in contact with them because of a mistake I personally made when ordering Maxim was SUPER DILIGENT and guided me all the way through the differences of the items SUPER kind and friendly Got me all set up and Sent me EXACTLY what I needed without a Glitch Loved the experience and will continue to do business with them AAAA++++++ Can not beat the Service and the product quality HIGHLY RECCOMENDED

Excellent quality. Anyone serious about shielding their RC flyers from outside interference and producing the best possible clear signal needs to change out their flimsy, original pigtails in their RC device with these from All in good time. They are very heavy duty and I installed them in just minutes in my Drone Controller.I used them for both antennas, one for the 2.4 GHz that controls the piloting and one for the 5.8 GHz that receives the FPV signal from the drone.I also modified the Drone itself with an external 5.8GHz (FPV) antenna and used one of these same Pigtails to connect it.I'm getting much more control distance and a better picture quality than I thought the Drone was capable of.Don't hesitate to get these.

Perfect fit for the external antenna on the ESP32 and Dig-Uno and Dig-Quads. Extended the range for the router to send and receive commands to/from the units.

These work great for replacements if you have that style connectors. BUT they even work better if you're into modding your anntenna connectors for different lengths...just cut to length and solder to your VTX (ref.YouTube) and your good to go!

Great product, delivered on time, packaged well, with nuts and safety washers included. Installed and worked like a charm.Two thumbs up!!!

I found this product to be of excellent quality and perfect for my electronics project. The fast shipping is also a blessing.

No issues. Well made. Low insertion loss (undetectable with my cheap network analyzer).

I had my antenna break on my multirotor, and Immersion RC pointed me to these. They worked amazing, and I now have spares as well.

I will use it to repair the VTX of my Quad drone. I hope it will work as expect.