K**U
Works great
Been wanting this for a while and finally gave in. It was easy to setup, but the instructions were not great. Had to go back to the online video, but that followed a slightly different assembly order so I had to jump back and forth between the video and the instructions. Once I was done, turned it on, and printed the sample [chinese] chess piece included. The thing came out awesome. No calibration needed except for leveling the bed.The frame is a bit weak. The material is 5mm think. Apparently there is an 8mm think version which would probably be stronger. I plan to add some bracing myself. The screws are tiny and I nearly stripped the head on a few due to their small size. The base plate that goes under the heat bed was warped, but since there is the heat bed, this doesn't make a difference.For the price, I wasn't expecting too much, but this thing works great. I'm sure after some upgrades this will be even better.
M**M
Buyer beware
Both my original and replacement arrived with no instructions on how to assemble. After searching the internet I found some instructions for a printer that looked like this one. First thing I noticed was that it did not include the plastic snips. I shrugged it off since I figured I could use wire cutters. Next I found that I did not have the right screws to attach the motors to the frame. I considered just ordering some screws instead of the hassle of exchanging it so I continued watching the video hoping to assemble so more of the parts so I wouldn't have as much to do later. That's when the unpacked the threaded rods, all FIVE of them. I had four so I went on Amazon two minutes later I had a replacement on its way to me. I received at work today opened it up planning to take out the pieces I needed. Well once again no instructions, no plastic, no m3x12 screws and no 150mm threaded rod! So after getting Amazon's help and they were helpful trying to get me to the proper people I found myself on the Cetus3D which I found nothing that looked like this printer there So I have decided to return both printers and go with a different model. NOTE that perhaps this printer did not need that rod and used a different set of screws that came with the machine either way without the correct instructions it is near impossible to say. Also if you are wondering and read this far yes I put the CD into my computer incase the instructions were there only one file was there and that looked like the software for your computer to communicate with printer. And to any left reading this thank you and have a great day.
R**Y
DIY headache
No instructions
S**.
Cd Rom does not work, can't test printer to see if works or not
Cd Rom that came with printer does not work. Tried to contact Cetus3D, no response, tried contacting CTC, no help, can't find any help with this problem. Just need a link to download the information to even see if it works or not. I need help with this ASAP.
Trustpilot
1 month ago
1 week ago
