Cat6 Keystone Ethernet Wall Jack Punch Down UTP 45-Degree (Easier Termination Than 90-Degree), RJ45 Slim Profile Speed Termination 45° Angled White (5 Pack)

I ordered these in somewhat of a hurry and when they arrived, I didn't really look too close at them, then, either, so the first time I realized how different they were, was in the field, at a repair, and in front of the customer. These jacks are set up to lay in the pairs much more naturally, and easily than the standard jacks I've used all my life. My first thought was, ugh, where is just a regular, normal jack.....and once I realized, these were all I had with me, I was pretty much forced to try something new......WOW, how freakin' easy was that! The pairs lay down at a 45 degree angle, instead of the usual 90 degree angle I'd used for years. Not only is the angle real easy to work with, the pointed ridge that separates the individual pairs is sharp enough to actually do that trick quickly as well. So the last hurdle to cross was how is my standard punch down tool, going to handle this funky angle stuff.....easily, albeit, with a little getting used to. All in all, if I was doing a big job, and had a couple hundred of these to terminate, compared to the standard 90 degree wire loom style, I could see these saving a substantial amount of time, not to mention cut down on errors In the pairs. Love them! Just need to pay enough attention now to make sure these are the style I order from now on. What a fortunate accident!

Second time purchasing this bag of 20 CAT6 Keystone Jacks for terminating LAN cables in a remodeled house. Excellent quality, fit and wire retention. Slanted wire runs make it easier to route the individual wires into place and punch down. Plastic cover snaps into place to cover/protect the wire connections. Each jack has a label displaying the T568A and T568B wiring patterns for visual reference. These Keystone Jacks have fit into various makes of Keystone wall plates and straps without any problems. Will continue to use these in the future - highly recommended.

These make replacing outlets in the house super easy. I actually think the angled design is more functional than the other style where the wire must make a 90 degree bend. These are super easy and I didn't even need a punch down tool, you can just press the top on and it will push the wires into place. they worked great for replacing a few in my house that had bent/broken outlets.

These take anywhere from 20-30 seconds off the clock for each keystone. Multiply that by 100, 1,000, etc... and you save a lot of time using these. So far of all the ones installed, they all work and pass testing.

Note: you do need a punch down tool to use this.The jack appears to be well made and fit perfectly into the wall plates I used.

I just remodeled a room and needed to put some wall jacks in. These worked great.

Super easy to use

Great cat 6 keystones. 10/10. Would recommend.

Recieved a pack of these. Very easy to use as they have the clear dust cover and the keystone in an individual bag. The wiring standards are labeled under each connector point. They have fit into standard keystone wall platers and sit flush. No complaints, would purchase again. Also one of the cheapest I have found.

They are what they are..... Cat6 RJ45 Keystone Jack -=- No complaints. - Make sure that you really push the cover (clear) tight, to ensure wire to terminal connection. - I had one (where it was hard to reach...and in the dark) where I did a "sloppy" job... sure enough, there was no connection to the network switch.I can only recommend them - colouring, that shows which wire goes where, si good too!