Laxllent Rotary Washing Line Cover, Protective Cover for Rotary Dryer Washing Lines,16x16x180cm (600D+PU Coating)

Great material very strong and fits my 4 arm rotary drier very easily. The cover comes with a fold up pole to put it on with and which fits into a handy pocket inside the cover so it's always to hand. The zip goes all the way to the top and has a long tape on it so you don't need to reach up to close it. When it's closed there is a flap which covers the zip much like in a windproof jacket. lt also has velcro on the bottom to secure it and a cord which you can tighten to stop it blowing away. Very well thought out in my view. My only quibble is there is nowhere to put the long tape once you have closed the zip and it is left flapping about. This is a small quibble other than that it's perfect and I am hoping it will last a good long time.

Just bought this cover so can’t comment on durability yet but someone really seems to have thought this product through. The top of sun umbrella on my table is really high and previously I had to climb on the table to put the umbrella cover on or take it off. This cover comes with a collapsible pole which you can use to lop the cover on to the top of the very high umbrella. Just open up the collapsible pole to its full length by pulling it apart, pop the top of the umbrella cover on to the end of the pole it and lop it over the top of the umbrella. Normally you still wouldn’t be able to reach the zip slider if it’s at the top but these folks have solved this problem by adding a long ribbon to the zip slider. The collapsible pole then folds down again and there’s a little slot inside the cover to store it in keeping it dry. The only tiny niggle is that the slot for the pole flops about a bit until you get it inside the zip but that’s a small detail. If this cover lasts a few years I will be more than happy.

Cannot comment on durability as only received 2 days ago but looks pretty robust and well made. The full length zip and 'roomy fit' make it easy to put on and take off the clothes line. Also nice and long so completely covers the arms and fittings.

I purchased this cover to go over a replacement Vileda 4 arm (60m) rotary line (a replacement purchased for one that's done stirling service for 10 years plus, but the lines looked like they would break and dump washing on the lawn if I kept it in service much longer !). The cover fits well, which was an initial concern as 4 arm rotary lines are quite bulky when folded up, but I needn't have worried. The cover fits so well, it could have been made for the job. While I am very impressed with the cover, at this early stage there are a couple of unknowns. It definitely seems well made and of a reasonable weight material, but only time will tell how durable it will be (my cover put in to use week commencing 18/11/2019). The only cause for concern I have at the present time relates to the 'wand' supplied to assist in lifting the cover up high enough to fit over the top of the rotary. The wand does what it is supposed to do. It is light in weight and of a narrow diameter and has protector covers on each end but ...... the top of the cover is of the same thickness as the sides, and I wonder if regular use of the narrow diameter wand pushing against the inside of the top to lift it may eventually poke through the material (especially after a few summers with the sun [I hope] causing the material to harden a bit). I see on another feedback (I think the customer didn't get their wand for some reason) they used a broom handle to do the lifting. I may well make a 'special tool' out of a broom handle with an additional piece on one end which presents a larger flat area to press against the inside top of the cover. If my fears were realised by using the wand over a long period, it would be a dreadful shame for the top to be damaged when the sides were still servicable.

Having had the cover for the rotary drier for just over a week, it is difficult to comment on it's durability. However, it seems sturdy and weatherproof and oes the job we wish it to do, that is cover a large rotary drier, admirably.The materials and the construction are very good. It is easy to fit, with or without the supplied fitting rods and so far we would rate the cover as excellent.

At last a cover large enough for my drier. It is a very strong fabric, and I like the tie-string round the bottom. The pole is so handy when putting the cover on. Strong zip. Arrived on time and is good condition. I would definitely recommend.

I am very pleased with this cover. I have a large rotary washing line which is about 18" taller than I am at 5ft. 2in. and find it difficult to get a cover to fit. This one fits perfectly and was so easy to fit using the collapsible metal rod to help lift it over the top. It is well made and covers everything completely.

It is sad that a rotary washing line cover can bring so much joy, but I love this product. It is bigger than my line which makes it easier to put on. The zip has ribbon attached to it to make it easier to zip up and down. There is also a velcro fastener and a pull tie making it secure and unlikely to get pulled in the wind. Looking at the material I think it will wash well. Best product of it's type that I have come across.

Gekauft, macht einen wertigen Eindruck.Ob u. wie lange das hält, wird die Zeit zeigen.Jedoch gut verarbeitet u. bestätigt wasserdicht.Reißverschluss praktisch u. erscheint haltbar.

Bonjour ce produit répond parfaitement à mes besoins il est d’une qualité irréprochable et très facile à utiliser je le conseille vivement

Ça fait le taf. C'est très bien pour le prix je l'ai depuis bientôt 2 ans, elle a décoloré mais est sinon en parfait état alors qu'elle est toujours dehors (on ne l'a pas rentré cet hiver)

Einfach praktisch!

Die Schutzhülle ist aus einem stabilen Material.Der Reißverschluss geht fast bis ganz nach oben was ein überziehen über die Wäschespinne sehr erleichtert.Der mitgelieferte Stab ist meiner Meinung Nachricht durchdacht. Er muss jedesmal zusammengefaltet werden und in der dafür vorgesehenen Tasche in der Schützhülle verstaut werden. Sinnvoller wäre es wenn der Stab, wie bei vielen Schutzhüllen für Sonnenschirme, dauerhaft integriert wäre.