Monoprice 5 Pairs Gold Plated Speaker Banana Plugs, Closed Screw Type

Bought it for my AV receiver and 5.1 system. COuldn't have asked for better stuff. Perfect fit. Great quality. Worth every penny

Good quality.Easy to fit wire.Somewhat costly

These are well built connectors and a good investment if you care about clean connections for your AV system. As several reviewers have commented, getting the length of the exposed wire just right is key to ensuring proper fit of the screw bottom. It should be just enough to spread out over the tip of the screw on the plain area before the thread starts. If it is longer and extend over the thread, it will be impossible to screw the body and bottom together and if you force it, it will either spoil the thread or break the wire. Once you do a couple of them, you will get the hang of it. Also, I found that my 14 AWG Amazon Basics speaker wire was too thick to pass through the hole unless i stripped off the insulation. You have to apply enough force to push at least the tip of the insulation into the hole to ensure a snug fit. In conclusion, this is a great product at a reasonable price, but the installation require some time and effort. I'm very satisfied with the end result.

Value for money. Full gold plated. Easy to use.

Good and very Satisfied with the Plugs !

These plugs fit well. Wire connections are not that great and lot of effort is required to get proper connection

excellent

quality is not good as shown

Non sono riuscito ad utilizzarli e quindi li ho restituiti.

Vorweg, die Stecker haben eine gute Qualität und sind schwer. Leider passen sie nicht in normale Lautsprecherbuchsen, sie sind viel zu klein.

I bought these to attach Amazon's speaker cables to the rear of my Onkyo receiver. They fit snug into the receiver and were simple enough to have the cable attach to. I've purchased Monoprice products in the past and they were always very well priced and superb quality. My mind hasn't changed with the purchase of these. However, I did realize after purchasing these that there are a sort of "spring-loaded" banana plug on the market that seems to fit even more snug. Regardless, these seem to work just fine!

Je les ai acheté sans trop regarder quel type de fermeture ils ont. Au début je ne savais pas trop comment y attacher le cable (toujours eu d'autres types...), mais après une petite recherche sur internet c'était fait. Il faut dévisser les parties épaisses, ensuite bien couper le bout de câble, le passer par le trou, repartir de façon homogène quelques millimètres des fils sur le côté à visser, sans dépasser sur le filetage, et visser la deuxième partie dessus. Le câble de 4 mm y passe encore, avec un peu de résistance. Pas plus.Ce que je n'apprécie pas, c'est le fait que les "pointes" de ces bananes se dévissent, à mon goût, trop facilement. Si on bouge trop sans faire attention les appareils ou les câbles, la partie avant de la banane peut rester dans l'enceinte et le câble peut se détacher et aller se balader sous risque d'un court-circuit. Donc, avant de l'insérer, il faut bien vérifier et serrer toutes les parties.

Very good item.. No need to spend a fortune on banana plugs these are good enough. Simple to uise: just strip back enough copper wire. Then feed the wire through the hole, fan it out just so it slightly goes over the top of the connector. Then screw it tight. Simple as that. Then put it into the banana plug slot on the speakers (once the plastic protectors have been removed) screwing the plastic / metal thread on the speaker binding posts all the way to the top.. Which holds the banana plugs in place. Never use bare wire when inserting speaker wire into speakers always use banana plugs.. even with spring clip type connections.