Workbench Stepdown Caster, Set of 4

Especially like the three screws at the bottom of the mount insted of one as found on some units. Should be strong enough to support a heavy structure. This unit used on a 300 pound cypress bench.

great product,add 1 inch to mount by instructions.

I bought these to go on a workbench that hardly gets moved. My thought was, why pay more when these will not be called upon to take much use? Well, I found these are horrible at even holding up the 200-pound workbench without wanting to roll or center themselves. They do not "snap" into place or hold their latch setting, the wheels or rollers are cheap and fell apart on a divider line/groove in the garage floor.Certainly not worth the cost or anything close to it.

This item is as described, but the instructions page was mostly whited-out due to what looked like lack of toner when it was printed. Even if they did exist, this is what I would do when you get your package:1) Open the box, find the junk screws, and throw them straight in the trash along with the instructions.2) Give the gloves to someone who could use them for light gardening or such (e.g. my wife will use them in the walk-in freezer at work).4) Throw the screwdriver in your spare tools drawer/bucket/whatever.4) Create a template using the flat back of the bracket for easily marking holes on the leg of your workbench.5) Place the bottom template edge 1" above ground and mark the holes with your implement of choice.6) Using long bit or bit extension on your power driver, grab some better screws (I just use grabber screws of the appropriate size for your application) and zip them in through the bracket holes and into the leg of your workbench.7) Repeat steps 5-7 for each workbench leg. ;)They seem to function just fine. I have yet to fully load my workbench, but they should be fine as I plan to stay within the weight specs.These were a fair bit cheaper than similar (almost identical) casters by about $15-$25.

Got them to put on my work bench worked great

Quality is not what I had expected. Very difficult to raise wheels to the up position.

Once installed works as intended. The pedel contacts the wheel mount with just sheet metal on metal. No bearing to help with wear over time so I think this will wear out.The screws are cheap, and half of them stripped out.That said, within the observations above, for the price it's a good value and functional

Quality. Fast service. Great price