Truxxx403019-2.0" Front Leveling Kit Compatible with Chevy Colorado (2015 to 2022) & compatible with GMC Canyon (2015-2022) ~ 2wd & 4x4 (4wd) ~ gas engine or Duramax Diesel

My review of the Truxxx 403019 is based on three aspects: Quality, Value, Installation.As far as quality, they’re not bad. Steel with some kind of black coating, presumably to protect against rust. As advertised, they are only 1.5” tall and yet they still lift the truck 2”. This left my truck about 1/2” taller in front than the rear. Looks level though.These aren’t the cheapest nor the most expensive levelers out there. But for $135 I think they’re a pretty fair value.As far installation, it took me about two hours. Note that I work on cars for a living. A fairly skilled do-it-yourselfer can certainly do this job. It was a bit of a chore getting the strut remounted since it’s a couple inches taller. Be careful with the brake and speed sensor lines.GET AN ALIGNMENT AS SOON AS YOU’RE DONE. This job WILL affect it: The upper strut fits into slide mounts that change the toe.Four stars mainly on the value category.

These leveling spacers worked great. They do cost a little more but not having to break down the strut saves a ton of time. Lifted my truck up to a perfect level stand. It took me an hour on each side.

If your going to level your truck you better do it right don’t do it the cheap way is a waste of money ,Use the AFE coilovers I know they are 10 times more expensive but it is worth every dollar!!!

Easy install, looks great with 1.5" leveling block on rear.

Garbage lift!

Bizarre j ai commandé 2 po et il ne mesure que 1po 1/2 je vais les installer quand même après avoir demander de retourmer l article truxx a refusé disant que c était correct comme ça même si il dise que c est 2po en fait ce n est que 1po1/2 P.S je trouves que ce produit est trop dispendieux j ai vu chez rock auto produit similaire a $65. Sauf que la livraison coûte $57. ????? Bon là j en ai mis un et je comprends ce que disait le fabriquant 1po1/2 avec le fait de la compression du coil spring donne 2po sauf que je trouves le coil beaucoup trop. Mis a l effort donc j ai enlever les spacer les ai coupé et remis en place avec 1/2 po et c est bien il porte mieux sur la route voilà