White Touch Screen Digitizer for iPad 9.7 (A1822, A1823)/Ipad 5 Ipad Air 1st Touch Screen Digitizer - Front Glass Replacement with Tool Repair Kits + Adhesive

First off I have repaired 70-150 iPads. These iPad airs have a flex cable (like a tab) that has to be folded over and adhered. If you do not fold it correctly, you get glitches and partial working screens. However, this screen brand and sold by First Choose was pre folded and adhered- Smart move by the seller.Second, I have tried 5 different sellers to get this screen with the copper color frame inside, it’s just a better screen.Third, there are no grid lines. Yes you read that right. Some cheap junk brands have little dots that you can visibly see (touch grid lines).So I recommend this seller “first choose” I purchased the iPad 5th gen screen. For model a1822.If you are a first time DIY’er be sure to watch videos and check out the iFixit website.If you have partial screen touch, check that both connections are secure (they should actually click on), one is for the top half and the other is for the bottom.I only wish Amazon had a way to save good sellers and block bad sellers.

Very carefully, neatly, and well packaged. If you don't know what you are doing, please watch some YouTube videos first. You will NEED heat, I used a blow dryer. And you must avoid some areas (2) so you do not cut cables accidentally. You will see in videos.

Good

I have a hard time getting the screen to adhere on all sides

Like brand new! If you know what you’re doing there’s no complaints

Thanks

It was ok.

It was the first time trying this. None of the tools helped open it, I had to use an x-acto knife. The tape with the kit was worthless too. The tape is important because it is how the unit is held together in the end. My son pushed it down a couple days later because it was popping up and when he did the screen cracked.