MEETOZ Diamond Hole Saw Tile Ceramic Glass Porcelain Marble Drill Bit Tool - 110mm

Good strong

Used both 150mm and 100mm sizes on 8mm thick floor tile and worked perfectly. I found start cut at high speed at about 45deg angle to tile then level out and when established can slow speed down. Used with a little water. Done several holes and still good.

Great price and value, does what it says, cuts nicely and cleanly into the tile leaving no imperfections, really chuffed with this, attached to my drill and used dry no water needed.

Ok, so I wanted to make a 6" hole through a cement (probably asbestos impregnated) panel.These are very hard to drill through so i have been putting the job off for ages.Stumbled across this on Amazon and thought it might be worth a go, as it is relatively inexpensive, and the only one i have seen that looked like it might work (having used a similar design to drill through porcelain tiles in the past) Also, i was offered same day delivery for only £6.95 which seemed brilliant, especially since it was actually delivered later that day! So, I covered the area to be drilled with shaving foam and used a cordless drill on slow speed. Had absolutely no problem with the drill wandering, as i gently let it start cutting into the surface. The trick is to apply very little pressure, and keep spraying the area with water. If you go too fast, it gets hot, dries out, and the diamonds get clogged and it stops cutting. Just be patient and it will gradually cut through. Afterwards, i inspected the end and it still looked like new. Overall, i would have to say that the product, and the service are as worthy of five stars, as anything i have ever bought from Amazon.

This hole saw was tasked with cutting 3 holes. It managed 2 and a half.The first 2 holes went well and the finish was good. Half way through the third tile, the saw buckled and twisted the cutting edge out of shape.Generous quantities of water were used on the cutting edge when in use to keep it cool and if the item hadn't crumpled in use I'm sure it would still be sharp.Unacceptable for a tool like this to be single use (actually 2 uses).£7 per hole seems a bit extreme..

Cut through tiles with ease.

I used it to cut through the initial glaze on two ceramic floor tiles which I laid around a floor vent pipe. Very Slow Progress! Used a diamond blade in an angle grinder to trim the hole once the initial glaze was cut through. Because to complete the entire 10mm deep cut with this hole saw would have taken ages! Cheap for a reason!

Flew through 10mm porcelain tiles like butter, you need to keep dipping it in a bucket of water to cool it down, better than spending £50+ just for the make.Well worth the money, definitely recommend 👌

No me ha gustado nada no perforaba encima de doblo y ya no cumplía su función

La he usado para perforar unas baldosas de gres y perfecto

J'ai acheté cette scie cloche en diamant pour faire les trous d'évacuation de mes toilettes (diamètre 100) dans les différents carrelages. Il fait très bien son travail et pour le prix c'est une affaire. Le seul reproche que je peux faire c'est qu'il n'y ai pas de foret de centrage pour facilité le perçage c'est quand même un gros diamètre. Sinon après 10 utilisations (chez moi et chez des amis) j'en suis très satisfait.

parfait. très bon outil pour le prix. diamant nickel après plusieurs coupe a l'eau. je recommande cette outil .

Muy buen resultado, muy buena relación calidad/precio