License Plate Lights 12V LED White Lamps for Ford MK2 Focus C-MAX (2Pcs)

I received my Lightdu License Plate Light LED Lamps Assemblies X001RTM72N. I am a Senior Electrical Design Engineer working on a custom License Plate. I have discovered a discrepancy between what is shown in the first photo of the LED light Lens and the actual specifications. The lens has 13.5 V 2.0 W CE, that is 13.5 Volts (DC) and 2.0 Watts, Conformity European. I based my initial design on what was on the Lens 13.5 V 2.0 Watts , however I did find in the notes for the device in the text of the ad where it stated 13.5V 3.5 Watts 30,000 Hour Mean Time Between Failure (MTBF). There needs to be a disclaimer on the ad to disregard the 2.0 W on the lens. Ideally it needs to be printed on the device 13.5 VDC 3.5 Watts. Additionally the positive tab needs to be identified. Now that I have resolved this discrepancy I really like my purchase and I have incorporated the LED lights in to my custom license plate design. BTW it looks “Factory”. I rate the Lightdu License Plate Light LED Lamps Assemblies X001RTM72N 4.0 of 5.0, If not for the dependency it would be 5.0 of 5.0.Very Satisfied,D. M.

One of my license plate bulbs went out and I thought I could just replace it. So after wrestling with the housing to remove the bulb it broke! So now I need to replace the entire assembly. Saw these light and read all the great reviews and made the purchase. MAN I WAS NOT DISAPPOINTED!! These lights are A MAZE ZING! Super bright, but not overly bright. Plate can be very easily read no problem. A very low price to pay for an amazing upgrade.

Installed in my 2011 BMW 528i. Lights are bright, clean and easy to put in. Very happy with purchase.

Would have given 5 stars if it came with the screws. Way more light than is needed for rear license plate.

WAY too damn bright in my opinion. Also these did not install on my 05 Audi A8 without some trimming. Had to drill the screw holes out a bit so the Audi screw head would fit into the recess, and had to file some edges to get it to fit, but only on the left light. Maybe it was just my car...However they do seem to be well made, and so far no error message on the dash. Just too damn bright. If they were half as bright, 4 stars.I'm going to buy CREE bulbs that fit into the original lens housings.

Installed them in a 2008 Audi A3 Sportback. They are not a direct fit. I had to remove some material where the light clips in and on the edge near the screw. Also...they are way too bright. If those two issues did not exist...I’d give it 5 stars. Otherwise...they are good for what I paid and how fast I got them.

Pluses: Correct fit, no error codes, easy installation.Minuses: Shockingly bright... in my version (BMW X5) each lamp assembly (there are two used, one on either side of the license plate), had 3 rows of LED's... for a total of 6. How bright? Pulled over by the police bright!Rather than go through the hassle, of returning and doing this all over again, I opened the lens and using a piece of black electrical tape, I covered two rows of LED's and used hot melt glue to reseal it... Now it is perfect! 3 stars because I had to mod it.

The gasket does not seal on an Audi A4 B7. I fixed the problem by taping around the light using 100-mile-an-hour tape. That stopped the water from getting inside the light and breaking it.