Cement & Grout Residue Remover is highly effective at removing general calcium-based haze. This product will also remove haze from portland cement pointing and jointing compounds. Cement & Grout Residue Remover can be used as an effective grout cleaner when applied to non-acid sensitive surfaces like porcelain, ceramic tiles, slate and Indian sandstone's. The dilution rate of this product can be adjusted to suit the surface contamination and the procedure can be repeated if required.Directions for Use:Use a safety mask, googles, gloves and suitable clothing.Firstly, wet the surface to be treated with clean water.Apply to the surface using a low-pressure sprayer (external application only) or mop. Can be used neat or up to a dilution rate of 1:10 with clean water.Allow around 10-15 minutes of dwell time, do not allow product to dry on the surface during this time.Agitate the surface with a stiff brush.Rinse the area with clean water.Repeat the procedure if required and increase the dilution rate if needed.Coverage:15-30m2 per litre dependant on dilution rate.Please Note:This product is acid based and is not to be used on any acid sensitive surface such as limestone, marble, cement-based pavers, travertine, terrazzo and concrete. It can also effect some metals including the vapours. Check the suitability in an inconspicuous area and provide good ventilation when working indoors.Important:Handling and StorageStore only in original container in a cool, well ventilated area. Keep container tightly closed.Warning: keep out of the reach of children.Instructions on our website and product label are for guidance only. In the event of perceived failure the manufacturer would be obliged to replace our product if proven to be at fault. It is the product user’s responsibility
Trustpilot
2 months ago
3 days ago
