HEWEGOAngle Clamp, 4PCS 90 Degree Corner Clamp, Multifunctional Picture Framing Holder, Woodworking Hand Tools

For what it is, it's not bad. You can't expect much for what you are paying for it though. The medal is that of die-cast. This devise won't take a lot of pressure, like really tighten down of material. I would say just snug the clamp and that's it. I use this for Picture Frames. I have found once frame is in place in this jig. I can level off the project and then nail it together.I had a picture I was going to enclose, but Amazon has taken this feature off. But for what you are paying, and depending on how light or heavy your project is. I would recommend this. This devise is better than trying to hold project and level and glue and nail without it. It's helpful to have in your jigs. It's better than nothing at least.

What the header says. These are light duty and not precision clamps, but they will get the job done.The clamping lips have a very low profile, and that can be good or bad depending on what you are doing.However, for heavy / thick boards, these clamps are not ideal. Where they shine is with light / thin stock or when working with acrylics. That said, you get a lot for your money.

These inexpensive corner clamps should not be confused with the expensive units manufactured for serious hobbyists and pros, but they are just the thing for smaller jobs like drawer repairs or building frames. They also function well as third-hand tools.

These aren't perfectly Square. Probably just fine when making picture frames, but not if you want precision. Sometimes you get what you pay for, sometimes you get more than you pay for.

Purchased to build and square up a small China cabinet door. Easy enough to use and did what I needed it to do. Glad I purchased this and anticipate using again for other projects (frames).

A bit clunky, but they bring the frame corners together nicely. Only disadvantage is turning the tightening bars on a flat surface. Tighten the clamp so there is a little movement in the frame first and then turn the bar over a couple of times. Works well on small to medium frames.

I have had these for some time now and when they first arrived I was excited until I opened it and saw one of the clamps was broken then painted over, I wasn't very upset because i only needed two at a time. However after the first use a second one snapped while holding 3/4" MDF together. For the remaining two I used them under less stress with more supports and they didn't snap (luckily).

If you need clamps, go get some. These, however, are a revelation for a solo DIYer making a kitchen full of drawers. They stabilize the panels so that I can get everything in place and then bring in the big clamps. I've been able to dry fit and fine tune my joints. Just a nifty little set. I'm treating them gently since they aren't heavy duty but exactly right for what they are meant to do.

Not very sturdy, not sure how long it will last

Great for small projects only

made a little cheap but may last we will see

Functional

Cadeau