Mota Performance A40212 Carburetor Spacer Kit Open Plenum - 1" with 3/8" PCV Tube Port

Only spacer for a Carter I found with the PCV valve port already drilled.Wanted a plastic one but they only make them for Holley's...

Used this to measure boost cause my intake didn’t have a port and this worked good but affects hood clearance

Everything was good. You do have to smooth it out. Has casting burrs.

Need this for my 429 in my '86 F150.

great product

Solid aluminum construction but had to clean off a few small burrs.Has a quarter inch NPT opening and comes with a plug and a barbed fitting. Also includes two gaskets and mounting studs with nuts and washers. Fourth grade with a fi-tech fuel injection system to keep the assembly off the hot manifold.

This is the worst quality in a casting I have ever seen, It has Flash ( Excessive Material) that literally fell off in my hand as I was taking out of package.The flash is on the inside next to your motor and would have fell into intake manifold then into the internals ( Main/Rod Bearing) of your engine.Do not use this part unless it has been 100% sanded or machined. It could kill your engine ,and I am not exaggerating in one bit ,I bought this for a New 427 Street Rod motor ,Thank goodness the defective part was quite obvious.

A little rough around the edges but I filed it smooth.