Room Divider Single Panel Folding Privacy Screen,Wall Divider for Partition

I liked this so much I purchased another one. Pretty sturdy. I love the privacy it provides. You can not see through it even with a light on. Great buy and easy assemble.

This room divider was easy to put together and is sturdy enough so it wont tip over if it's bumped.Included instructions weren't very clear and some parts weren't labeled, but once you figure out how to put it togetherit works as expected. The material is a bit wrinkled so if that is a concern you can iron it prior to installation. The size is fine for a smaller room and the thickness of the material is fine for it's intended use.

This room divider does the job when fully assembled but getting it the assembled part is the problem. The divots in the poles are not consistent so you have to put the washer on opposite sides on the top and bottom - see video. The biggest problem was getting the cross bar to screw into the uprights because the plastic insert on each end of the cross bar rotate with the screw so it’s impossible to screw in and secure unless you’re able to immobilize the plastic insert - I used a wrench clamp coupled with a power drill. Once it’s fully assembled it’s fine but I need to be able to assemble, disassemble, and store away quickly when not in use and the headache to do so is just not worth it.I’ll be returning this and looking for a better alternative.

Sorry of does the job I need. I did order a folding style. I assumed ( my bad) this came down quickly. It doesn't. If you need a permanent fixture it's ok need more versatile, not recommended

The 3 partitions I purchased were of good material but were shorter than described and the "feet" on one end of all 3 partitions was skewed a few degrees so I cannot butt them together side by side. PHOTO #1: you see me who is 63.5 inches in my shoes standing next to the 72 inch described partition minus the wheels so it is fair to say it should be 70 inches. But even so, 70 inches minus 63.5 equals 6.5 inches that should be above my head and should not include the tip of the pole and a 6 inch gap below. PHOTO #2: shows the gap when a 90 degree good end is butted against the skewed end. Good material and easy construction but just make it taller and fix the jig that skews the bottom bracket weld.