12mm drilling bits

Buena calidad. ..

These arrived and though I haven’t used it yet, I have been observing how sturdy their construction seems. These are great for dowels in furniture. Highly recommend these.

No issue

I have a set of smaller dowel jointing drill bits but needed some with a larger diameter for a project I have been working on, and these are perfect. They fit perfectly and securely into to my dual spindle dowel jig and performed very well. They come in protective sleeves, which is extremely nice to keep them protected, but more importantly, keep me and my son protected. He is just learning to properly handle sharp tools. The shafts are also secured in a hard plastic holder. This makes them easy to handle and move around safely, but they are difficult to pull out to use. I had to tightly grab the spiral part of the bit, which is not sharpened, and use some force to pull them out of the socket they are in. I really didn't like the amount of force I had to use. A person without a lot of hand and finger strength might have some difficulty doing this. The actual cutters are very sharp and do an excellent job. However, just like any other sharp tool, these could easily cut the skin if handled inappropriately. If looking for drill bits for dual dowel drilling, you can't go wrong with this set.

A carbide cutting edge is the hot ticket when cutting manufactured-wood materials like MDF, masonite, particleboard and even plywood. These are a durable alternative for making holes in those materials. These have a brazed carbide tip with a clean four-facet grind leaving a brad-point in the center. The cutting lips are slightly hollow-ground producing a bit of a spur at the edge to sever fibers and reduce tearout. The cutting-lip edges are chamfered to also contribute to a clean-edged hole. I like these and they save subjecting my brad-point bits to abrasive materials. There is a flat on the shank which I expect registers them in the doweling tool they're intended for, but you can chuck them up in a regular drill chuck as long as you avoid that flat with any of the three chuck jaws, which is how I use them. Overall, I'd do it again and recommend. The price of $15 each (two for $30) seems a good value to me.