Polymaker PolyLite LW-PLA - 1.75mm - 800g - Grey

The filament arrived in good time and in good order. The prints came out well with layers firmly bonded.

Great Pla for using on the bambu A1, prints well and great price. Also used it in my 3d pen and worked well.

Great when you get correct setting correct

Absolutely impossible to dial in on my qidi Q2

Iam a Rc plane enthusiast ,few days back I bought this filament for less than 3500 / 800 grams . Now the price is very high. Please encourage RC hobbists by offering with minimal margins so that more people will use your product. Quality: Good quality Price : very High

I had two spools that printed no problem, but two spools that were packed too tight causing binding and causing the print to fail. I really like the filament when it works, but the fail issue is terrible. The texture is gritty so it is more likely to get stuck. The sticking is only due to it being compressed against the roll walls, nothing to do with the printer.

Ne ormai stampati diversi kg per i miei aerei, un po ostico da stampare, ma quando si è trovato i giusti parametri, stampa bene

The important bits: layer bonding and strength is incredible! very rigid and much lighter than PLA or PLA+ but heavier than foaming lightweight PLA. I am going to use this on all my future 3D printed planes! Now my long boring story :) Patience was the key with this filament! I have seen too many great reviews to think that there was an issue with the filament itself. I took the recommended approach of printing using PLA settings and increasing the retraction distance and speed to the settings recommended on polymakers website. My prints were completely unusable initially. I didn't have a lot of time after work to run calibration tests but I did what I could in my free time. I would change one setting and print a part, I didn't write anything down and I didn't keep track of my changes. The poor print quality was completely my fault for not taking the proper time to dial in the print settings. I even tried multiple slicers! I finally had a day off! no chores, no work... time to get this right :) I started with the basics, e-step calibration and PID tuning. Those were very close to perfect already so I knew that wasn't my issue. I started back with the defualt PLA settings and did a retraction test (two 10mm cubes spaced 40mm apart). I would do a print and take a picture, record the settings and results and then make only 1 change to 1 setting at a time until I got the setting dialed in. Then I would move to the next setting. Rinse and repeat until I got everything dialed in. About 10 hours later, a nearly perfect print with just the smallest amount of stringing! Don't do what I did and just get frustrated and start throwing different settings at this stuff! It took the perfect mix of speed, temp, retraction speed & distance as well as extra prime after retraction to get this stuff dialed in. A change to any one of those setting will throw off the print! Cura 5.10 Artillery Sidewinder X2 (love this printer!) Fulament magnetic flex PEI bed Temp 190 Bed temp 60 (I always run 60 for everything, just seems to work) Print speed 40mm/s Travel speed 250mm/s Retraction 3.5mm Retraction Speed 35mm/s Extra prime after retraction .36mm My issue was an extreme amount of stringing and oozing. I am printing a single walled print and it is important to have a strong Z seam. The loss of material during travel moves and layer changes made the Z seam very weak.

Tudo ok. Obrigado