EyeO2 for Samsung Galaxy Note 8 Screen Protector 3D Curved Full Adhesive Tempered Glass Guard Anti-Scratch, Anti-Fingerprint Full Cover Screen Film Case Friendly 2 Pack

The first two-pack I bought was fine. The second was decidedly not. The first one didn't fit properly within the guide and cracked when I tried to put it on. The second seemed okay at first, but (over night) an odd line of bubbles appeared along the right side of the screen that cannot be pushed out. I even tried pulling it up and reapplying. All of the other bubbles went away... these did not. It appears as though there's a defect that prevents that part of the protector from adhering properly. I'm not sure what to do because I threw the packaging away when the second one seemed to work okay last night. I'm really irritated!This is the first full-adhesive tempered glass screen protector I've found for the Note 8. The packaging and instructions were good. It took a few tries to get it on with no dust, but I knew that would be a challenge -always is with full adhesive protectors. So far, I like the responsiveness and clarity. I downgraded to 4 stars only because of the black outline that extends down the sides, which makes it hard to see the edge pull "tab" and limits the full effect of the edge screen. Without the black sides, it would be 5 stars.

This is one of the only full adhesive screen protectors that I could find for the curved s9 screen. I was excited about the 2-pack because glass protectors have saved many of my phones, but one of them had a flaw, tiny bubbles in the glass (see pic). So I installed the second, and it went pretty well. There were bubbles but most were easy to work out. There are two however at the bottom left and right corners that won't budge. The protector seems to be lifting a bit there, so no matter what I do, the air just goes back in. Hopefully they don't annoy me too much.I did have to turn on the Advanced setting to make the screen more sensitive and now I feel no difference at all. I will see if I can reach the company about the one with the bubbles.

I got a Bare Pane protector because a saw it on Facebook and I ordered it on impulse. It was 30 bucks, a single protector and was terrible. It wouldn't adhere completely, eventually cracked while trying to get it to stick and customer service sucked. The part that did adhere looked great though so I wanted to give a full adhesive glass protector another shot. This EyeO2 protector was less than the Bare Pane and has two protectors. It comes with two full sets of cleaning packs, a precise fitting alignment frame and an excellent aplication tool made of strong plastic. Not cardboard. The edges are smoothed and rounded over. This makes them less prone to chipping unlike the Bare Pane which had a thin sharp edge and the glue goes all the way to the edge. You can see it squeeze out ever so slightly as you purge the air. Not like the Bare Pane. Adhesion was very good with one exception. I had my phone in a hot steamy environment and a small section in the corner formed a small set of bubbles that won't squeeze out. It seems to be between the glue and protector and not the glue and screen. More time is needed to see if it becomes a real issue. Also the screen is a little less sensitive so typing must be done with slightly less speed and slightly more intent.If you swipe type it's the same as no protector. The pen on the Note 8 works fine. Minus one star for the bubbles that formed but I've recommended this protectors to others regardless.

I thought this thing was awful. The first one I pulled out had a ton of tiny bubbles before even peeling off the backing. They would not go away no matter what I did. Eventually the glass cracked.I tried the second one and it was pretty easy to get on and only took a minute to get the bubbles out. About the only good thing I can say. Unfortunately, it's just not enough.The glass has a black border. That wouldn't be a problem if the border didn't cover part of the screen. It looks horrible. Also, since the screen protector doesn't cover the full screen, you can see light coming out of the side. Look at the phone from either side and you see a bit of screen with a black line running top to bottom.At this point it's more difficult to use the phone. Yes, I enabled the touch sensitivity. Yes, it helped. No, it isn't working as it should. There are constant response issues.This is an awful screen protector.Update:One week in and I have to say, this thing is actually WORSE than it was before. Within 24 hours, small bubbles formed just like the first one. Not as many, but still present. They appeared in the top left corner. A few days later some formed in the top right corner.I ended up trying a different protector, pulled this one off and found it was defective. Slapped this back on just so there is some protection. There are huge bubbles now. No I didn't expect it to stick properly. What I also didn't expect was the bubbles (not the tiny ones) to actually fix the sensitivity problems. Works great now. Not that that's really a good thing considering it looks like crap.

first of all, one arrived completely broken in half right of the box! the second one was sort of useable but you can see like drips of glue on it. they're not bubbles, they were there before i even took it out of the plastic. nor is it cute little dots that look like bubbles, it is dried GLUE running down the whole right side of the screen. additionally, the squeeze card (i believe it was called?) put a chip in it already. there are two positives, the dust stickers they come with are really nice and big. and the tray is really convenient and i'll be keeping it to use with other screen protectors. but those two things together, maybe worth $1.50. i'm mad. i've never really been mad at an amazon purchase, but i'm mad. i spent twice as much on this than i could have spent on something that performed 5x better but lost its stick with time.