Left & Right Upper Side Central Dashboard Cover Strip Trim 55436-02330 55435-02370 Compatible with Toyota Corolla 2010 2011 2012 2013 Dash Board Navigation Panel Strips Frame Moulding

Not fit like original one

The Getfarway Left & Right Upper Side Central Dashboard Cover Strip Trim (55436‑02330 / 55435‑02370) is a solid replacement set for refreshing the interior of my 2013 Toyota Corolla. Both pieces fit perfectly, line up with the factory mounting points, and snap into place without any gaps or alignment issues. The finish matches the OEM texture well, giving the dashboard a clean, updated look. If your original trims were faded, cracked, or loose, this set makes a noticeable difference right away. Installation is quick and straightforward—just basic trim tools and a few minutes of work. For the price, this is a great value and an easy way to restore the upper center dash area. Durable, good‑looking, and definitely worth it for anyone wanting to freshen up their Corolla’s interior.

ممتاز

غير اصلي وانعدم مع الشمس

Looks and fits like OEM trim pieces. The right side trim piece I did have to leave out and let it warm up so it was easier to install. But trim pieces do fit and look exactly like OEM trim pieces do.

The product looks great and fits perfectly with a little modification. The picture shown is misleading because it shows both parts on the wrong side. I had pulled the old ones off many weeks ago and when I went to install them recently I thought it didn’t fit because I was going by the picture. It wasn’t until I flipped them that I realized I had them on the wrong side. Then when I installed them correctly I noticed that at the top it was sticking up just like on one of the other reviews on here. So when I pulled them off I realized that there is a tab on the side of the ventilation duct that the top piece of the trim is supposed to snap into. Unfortunately it wasn’t going in because the plastic snap piece on the underside of the trim piece was too thick and it was preventing it from pushing down onto the channel and snapping in place. I discovered this when I removed the ventilation piece off and tried putting the trim on the upper side of the ventilation piece while it was out of the dash. I could see by looking on the underside that it was not going through because the plastic part of the trim piece was to thick. So I had to trim the piece on the underside of the trim on both pieces and that finally did the trick. Of note, it is easier to put the trim piece on after the ventilation piece is put back into the dash. Trying to put the ventilation piece on with the trim is a no go. Afterwards everything fit perfectly.