StanchevStanchev Crystal Protector for Moonswatch,Soft TPU Anti-Scratch Screen Protector Compatible with Swatch Omega Moonwatch,HD Clear Screen Protector Cover for Omega x Swatch Moonswatch 5 Pack

Great quality, tick layer, feels strong to protect, really sticky, invisible 100%. Just buy it, for a moonwatch is perfect

Bought these a while back and finally had a chance to "use" them.It's a good thing they give you a lot, because oh boy are they junk. I've used screen protectors for various electronics since forever and even other Moonswatches, so it wasn't my first attempt to apply something like this.To start, two of them had visible debris stuck to the protector after I removed the protective coating and were immediately thrown away. Then add to it most of the "kit" they supply is a repurposed cell phone accessory, including barely intelligible instructions using a sketch of an iPhone as an example and rectangular "guide stickers" clearly intended to go over the top and bottom of a phone.But I had three more, surely I could get those to work even with sketchy instructions. I mean honestly, you don't need instructions to slap a sticker on a watch crystal. So I cleaned the watch face with the included kit, slapped on a protector and.... bubbles. Bad ones. Well I had two more, may as well peel this one off and start over. Should be easy, even the ad says it has "flexible protector max coverage to the edge of the cell watch radian" (what?) so I could be able to peel it up easily. It was... I just wanted to mention that quote.So I clean the watch face again and give it a second try. Only one bubble this time but it's a decent size. So I rub at it with my finger nail to try to move it, no dice. Oh well, there's a third one and they were cheap I'll try again and have a good laugh when it fails too. So I peeled off the second protector, recleaned the watch crystal, looked it over annnd... there's a brand new scratch, exactly where the last bubble is. A good one too! I looked the watch over before putting on the protector, because I've worn it a few times and wanted to be sure I cleaned it well. So, I either managed to scratch my crystal while cleaning the watch with their included (phone) cleaning kit or I scratched the crystal while trying to push out that bubble with my finger nail... through the screen protector, that's intended to protect the screen from scratches.Ladies and gentlemen don't buy this product. It's not worth the $7 you're about to waste.TL/DR: Absolute bottom tier junk and there's a reason that the better version is sold for $21.00 on this very website in a two pack.

Great item this will help very much in keeping my timepiece protected from scratches.

Bought these crystal covers to put on a Moon Swatch. First one out of the box worked on a Mission to the Moon. Followed the instructions except for the guide strips they recommended using. Worked under a bright light to line the cover up with the edge of the crystal. The cover didn’t work so well on a Mission to Neptune watch. There were 3 small bubbled areas after the cover was set down. I don’t know if these covers are self-leveling like others I saw listed on Amazon. The bubbles aren’t extremely noticeable. My objective was to cover the crystal to prevent scratches. Leaving the watch sit flat for a day or two to see if any added improvement occurs. The Stanchev protectors should do their job. I must admit, on the Mission to the Moon watch, you cannot even tell the cover is on. Scratches were buffed out with PolyWatch prior to putting the protector on. Looks good.

I have a very, very expensive swiss watch and this is EXACTLY what I needed to protect the face. It applies easily and is naerly undetectible unless you look closely.

It looks clear and crisp on my Omega, Omega x Swatch watches when applied correctly. Here are a few things I notice,1) If it is your first time using this product (like myself), you may not get it perfect in one shot, thank god it come with 5...2) Small bubbles will cure by itself within 24 hours, so just leave it if you see some.3) If those bubbles did not disappear, lift half of the protector up, cover your thumb with the cleaning coat, then use your thumb to push it down again starting from the center.Hope it helps!

Watched the YouTube videos from other suppliers on how to apply and went through all 5 of the protectors trying to apply it to my watch and it will not stick properly. Poor product.

I see why they include 5 screens.... Your gonna mess up trying to install them! First off, no instructions, so use the videos on the product page. We'll it's not exactly showing the same product as received. First off, the crystal sticky side vs. the outside is not labeled. So first install attempt I guessed wrong and had sticky side out... had to trash it. Second attempt misaligned and had bubbles. It would be nice if the peel off layer had a tint to it so easier to align....as the video showed. It does stick good and almost hard to pull off. Trashed it. Third attempt, looks OK.. but does have small bubbles that won't come out regardless of how hard i rub it. I may try to learn to live with it as I suppose it would help against scratches. Only have two left. Function over looks I guess. OCD not happy.