Specifications: Power: 400W Power supply: 110V 60HZ Weight: about 13.2 LBS Ampere for welding: 0.5~50A, Continuous adjustable (Fluctuation) Package listing: 1 x Welder 1 x Cable 1 x Foot Pedal 1 x Forceps Clamp 1 x Tungsten Needle Operation steps： 1. Plug the device into the wall socket and turn it on. 2. Adjust input current by adjusting the current regulating dial to 1-1.5 to start. The current regulating dial ranges from 1-8. The dial can be adjusted as necessary depending upon the current flow. 3. Check that gas is flowing over the tungsten tip with your finger. Adjust Argon gas until you can just feel the flow. 4. Clamp the object to be welded with the negative ground electrode. You cannot short circuit the machine by having both the tungsten needle and the ground clamp in contact through the work piece at the same time. Do not have the target work piece in direct contact with the tungsten needle. A 0.5mm arc gap is necessary for pulse welder operation. This is the optimum distance for welding. 5. Insure you have arc welding eye protection in place. The arc emits short wave UV radiation that will cause eye retinal burns and skin burns. Cover exposed skin (a shirt is fine), wear gloves and use an arc welding helmet. 6. Briefly step on the foot pedal and release. The arc will have pulsed and spot welded at the point you had the tungsten electrode. Attention: 1.When you step pedal, do not touch needle or soldering metal ; 2. Spark light during the welding is harmful to eyes, please make sure good protection measures; 3. Do not step on the pedal with long time, just step it 1 time then move off immediately. Long time stepping on the pedal, machine will be short circuit, even to burn out inside electricity.
Trustpilot
1 month ago
2 months ago
