Amtech U2020 Universal Tap Adaptor

Really surprised at quality and the fact it works. Used on mixer tap first. Learned the washers really need to be fitted correct way, Or it leaks (obviously) Once I fitted them correctly, No leaks. Then attached it to (standard) cold water bath tap, And have left it attached for convenience, with no problems using tap as normal. Then just attach hose when needed. UPDATE! Been using this now since February 13th, Still no leaks or problems 3 months later.

This is a great product and does indeed fit to most indoor taps for your hose. It can be fiddly taking sometime to get it to sit in the right place so the water doesn't squirt out but with 2 rubber fittings it will work. You have to turn it tightly though.... this is where the 1 star comes from.Due to having to screw it so tightly so the water doesn't squirt out the plastic began to split. The tighter I wound the more it split and as soon as it was split it was no good.I have had a Hoselock one for years but the sort the bare end of the hose connects to so needed this sort as we have a new hose. As a result of this cheaper one splitting, I have now bought a Hozelock one where the quality is much higher.If it hadn't split it wold have been 5 stars.

This works it you place the tap in correctly and do it up tight enough. It can be adapted to different sized taps by selecting the appropriate washer. I bought this one as it didn’t cost much, just in case it didn’t work but it did. I’d advise going for this one rather than an expensive brand,

This clipped onto my tap fine. But it did keep leaking water. So used the rubber washer from my old broken tap adapter. The rubber washer in this one was quite hard. So don’t think had much give to mould. Might of just been my tap? But it has held well now for a few days.

Didn't fit the kitchen mixer tap properly and water leaked out. It wouldn't fit at first on to the bathroom taps because the tap lever faces forward when shut off, meaning that there is not enough room to fit the connector.But once I realised that the tap lever can just pull off without even needing tools and can be put back on in a different position I was able to fit the connector with no leaks.