Creality Original Ender 3 Nozzle Fan DC BRUSHLESS PD04010MS4 DC 24V 0.10A Cooling Fan 40mmx40mmx10mm 4010 Sleeve Bearing for 3D Printer

I have a print farm of six Ender 3 printers, and keep these on hand to keep them running. For the price of the fans compared to the potential cost of downtime, it makes sense to keep them on hand. I've found they last at least as long as the stock fans, if not longer.Would buy again without hesitation.

After 2 years of owning my ender 3 the cooling fan started to get very loud. These fans were a perfect cheap replacement. Better yet they were an exact match to the original design so they fit my 3d printed bullseye fan duct without having to modify anything. Best part is it's a 2 pack so next time it starts getting loud again I already have a replacement.My printer runs nearly 24/7 and the 1st fan has held up very well nice and quiet for many months. I'd say they are on par quality wise as the original that came with the printer and should last as long before getting loud again.So I have zero complaints good fans at a good price a++.

A surprising improvement. I damaged my original fan through clumsiness, and ordered these replacements to fix it. I used some of those heat-shrink-with-solder-in-the-middle tubes and it went super smoothly. The new fan performs great and is very nearly silent!

But it's only long enough because it comes with an extension clip, which puts a little awkward bulge in your cable wrap.

Needed a replacement part cooling fan for an Ender 3, and tried an alternative fan that cheaper, and labeled for an Ender 3... but the fan output was not the same.. which showed on prints. SO, picked up this set. Solid go to if you need a direct replacement.