EPEVER MPPT Solar Charge Controller Tracer A Series 10A/20A/30A/40A with 12V/24V DC Automatically Identifying System Voltage (30A+MT50)

Overall ok

Excellent charge controller. This is my 4th charge controller as I'd been trying to cheap out and avoid spending a significant amount of money on one. I have it set up in my van conversion where I t's connected to 2 X 100W 12v panels connected in series which are parallel connected with a 340W 24v panel. My batteries are 2 X 110ah AGM's. This controller could be considered overkill for my setup but I wanted to have a degree of future proofing for if/when I do any further upgrades. I'd previously had 2 PWM type controllers and a cheap MPPT one too. None of them hold a candle to this one though. My batteries are constantly held in a full, or at least a very high state of charge and the controller is constantly and accurately monitoring them and supplying the exact amount of voltage and amps the need. When the batteries are full it supplies just a small float charge the maintain them but as soon as you switch on appliances and start consuming power it draws more from the panels and delivers it to the batteries at the proper voltage for them. The remote display shows lots of very relevant information but for geeks like myself you can use the supplied cable to connect the controller to your laptop for charts, graphs and real-time stats. I should have just spent the money on this in the 1st place instead of wasting money on cheaper controllers before making the sensible choice and buying this one. I can also happily confirm that this controller does genuinely have in excess of 99% efficiency.

There are all sorts of settings for your solar set up, but to be honest, this is pretty much plug and play. We run lights, charge many different phones and tablets etc, and run a compressor fridge at full power from our single 175 watt panel. Our battery has never yet dropped below 13 volts.

Have had this unit for about two and a bit years now and has been working quite well, but it has a separate monitor that is good but a bit frustrating as haven't been able to set the clock so am unable to use some features of the unit . Which is a shame, this why I gave only 4 🌟

The media could not be loaded.  Easy to install and I used 10mm sq cables from the controller to the 3 x 115Ah flooded batteries. The remote unit is a nice touch and the display shows lots of infomation. You can setup the controller from the remote. I used a 60amp circuit breaker inline as an isolator to be able to isolate the solar panels from the controller. As per the instructions I only switched on the solar panels to the controller as the LAST step.

Had the product a few weeks then noticed a fault. I contacted the seller who resolved the issue very promptly. I'll definitely be dealing with these again for future products.The solar controler does everything I want it too and is easy to set up and use.

Bought this to set up a solar energy system to light my garden. The controller was easy to link especially with the added remote MT50. Excellent customer service too, very helpful. I recently had a query regarding the remote screen, my message was answered the next day. I would highly recommend this controller.

EPEVER are as good as or better than some of the better known and more expensive marine brands and much better value. Good performance and the older models I have purchased have lasted well in a marine environment. Sturdy cable connectors and easy to install remote display.