3D Printer Filament - Gradient Translucent PETG, 1.75mm Color Change Set - Blue Green/Pink White/Blue White/Purple - 4 * 250g

This PETG Filament worked much better than expected. It laid down the 1st layer evenly, good plate adhesion. No stringing, globs anything. Hit the sweet spot with my default settingsPS the colour is great.Bought a Blue/Green at the same time not tried it yet but hope it is the same.

I purchased 3 of their Translucent PETG colours ( Pink & White, Blue & Purple and Blue & White)Dialled them in with a few calibration tests and after an hour started printing, did not have to put them in a dryer before hand and worked out of the box.These came out better than expected and loving the effects on the prints. Adhesion was great and came of the plate with ease after letting it cool for 5 minutes. Would definitely recommend these as they are great colours and print so well.

Prints well good colours

Really nice material thank you

The filament prints well but the finished object is not translucent unless thin walls are used, the object shown in the picture must have been printed in spiral mode with one wall thickness. Models I have printed appear in a solid colour.

The media could not be loaded.  Prints really nicely, even at high speeds. Great finish and very little stringing.A word of advice: for chunkier prints, this has some nice banding between the colours. For smaller prints, you may need to fill your print bed to get a transition between the colours in the models.

This frosty looking roll makes things look exactly that frosty great effect and the bonus is it's easy to print high quality petg had no issues with it sticking to the bed plate and just and all round good experience good job on the petg !

Recommending

Premier achat de cette marque et je ne suis pas déçu, impression parfaite sur ma Prusa. T°220. bref j'en recommanderai.

Impression sur Crality CR10, T° 225°.Superbe rendu, plus transparant ( transluside) que d autre marque, tres brillant.

Me a gustado mucho el acabado que tiene y la facilidad para imprimirlo, extrusora a 235 y la cama a 80 , se pega muy bien a la cama, lo único que como no lo pongas a menos de 230 se atasca y el extrusor no es capaz de empujar el filamento, si lo calientas con una caja secadora no poner mucha temperatura 35-40 está bien sino se queda pegado el rollo y le cuesta desenrollarlo . Por lo demás bien filamento y con bastante dureza, lo uso para hacer piezas para la moto o cajitas de almacenamiento y de lujoEs la segunda vez que lo compro

Mooie kleur, maar je hoort heel de tijd plofjes, dus ik denk dat er vanuit het fabriek niet echt naar vochtigheid wordt gekeken.

Solide et transparent