Hand Held Brake Bleeder Tester Set Bleed Kit Vacuum Pump Car Motorbike Bleeding

I was having major problems getting ANY pressure whatsoever thru my newly fitted motorbike master cylinder.Spent many fruitless hours trying one 'trick' after another to no aval.This little baby arrives, a quick read thru the instructions and within minutes the brake was working perfectly!I was so thrilled, I proceeded to bleed other brakes that didn't really need it!!! I really did!Far and away the best toolbox tenner I've spent .

I've struggled for 15 yeas to bleed the brakes on my Yamaha 600 diversion.Finally bought this and the only question I have is why I waited so long!Took about 5 minutes to read the instructions and get it working.Was then able to flow brake fluid to the front calliper and removed all the air.Did the back calliper just as easy.Two tips.Warming the short platic tube in hot water makes it easier to fit to the vaccuum unit.To put it back ibn the box, this short length needs to be removed again. Careful use of a cupfull of hot water softened it.

Broke on first use!The plunger that builds pressure is plastic and cracked off almost immediately rendering it useless. Also the supplied fittings for attaching to the bleed nipples not one of them would fit on my bikes Brembo calipers - either too big which wouldn't produce a seal or too small to go over it even with a bit of oil to lube it. They are also made from firm plastic which makes no sense to me as how would you get a seal? Had to couple it to my old bleed kit to start work, then it broke :(Returning for refund.

I bought this as I was struggling to bleed the clutch on my Aprillia 1000. I think these are primary designed for bleeding car brake systems, so I was a little enthusiastic when I started pumping and setting up the vacuum. The clutch master cylinder on a bike is tiny, so I drained the system several times before I got the hang of setting up a small vacuum and watching the fluid level very closely. That said, these work very well, you just need to know how to use them on your vehicle.

Really great bit of kit which made bleeding all my new motorcycle brake lines a cinch. The unit creates negative atmospheric pressure (suction!) that draws the hydraulic fluid through the system via a bleed nipple into the inline cannister. Save hours of absolute frustration by using this unit. Fantastic product.

Well worth the money. The fluid comes out in a froth so hard to see if bubbles are all out, so I finished off bleeding with a tube and jar the old way. It draws fluid through hose very well. Have to be careful with black plastic connector over nipple as can come off, but a cable tie helps.Prompt delivery in only 2 days by standard delivery method.

Use this for bleeding the brakes on my bikes. Made life much easier than the usual pumping the level method, which would always leave air in the lines somewhere. Not as good as a pressure bleeder, but they're double the money. Can't fault it for what it gives you. If you're having issues bleeding brake lines, get one.

Having tried, unsuccessfully, to bleed the clutch on my Honda Valkyrie using a basic system, I decided to try the vacuum pump kit.It worked perfectly. No problems with the bleed valve adaptor and I have my clutch back!One tip – warm the plastic tubing first. It will help fitting the kit together.