DAYUAN Diesel Injector Puller M8 M12 M14 Adaptors

2010 bmw 1 series n47 engine, I had two injectors seized in and the tool got them out easy enough. One of them took some going but it got them out saved me a world of pain and the price is exceptional. Would buy againM14 adapter used and the injectors were Bosch.

Used it to remove stubborn injectors which i had been quoted 300 pounds made the job so much easier would recommend.

Great value , does the job its required to do , well worth the money without a doubt

As described and of good quality

This tool is all you need to remove injectors. BMW m57 3.0d and they came out no problem. Car is an '07 on 160k. 1st time the injectors have been taken out. A great tool for the job. Genuinely impressed.

I think the product is fine it was just to short for my liking to get any good leverage from the slide.

I had a leaking injector seal on my car and this resulted in a massive build up of carbon around the injectors and hence I needed to remove the injectors and replace the seals. Quite simply the job would have been impossible without this tool - even on the injectors that didn't have a problem it was necessary to use this tool to get them out.On one injector it took almost 30 mins of using the slide hammer on it (and some WD40) but the tool got it out. It might have been easier to a heavier slide hammer but I think if you are willing to spend the time then it shouldn't matter too much.I have used a more expensive set in the past but this one was just as easy to use and absolutely fine as long as it will screw on to the end of your injector. Definitely a must have tool for this sort of job

Bought it to do the injector seals on my 3.0 tdi, had no problems getting the injectors out. Its cheap but fairly sturdy.