12V，40W heater. DIY hotend requires heat sink to operate properly - metal base, aluminum block, or any other type of cooling deviceAssembly of this device is straight forward. Please consult with supplied drawings and pictures for visual clue. Thermistor mounted with clamping screwFeature- 30mm long stainless PTFE lined barrel-NTC 3950 100K pre-wired thermistor-Low profile: only about 43 mm high- Nozzle is based on MK8 makerbot nozzle geometry and can be exchanged or replaced with many different types of nozzles on the market-This will give you good selection of nozzle orifice diametersNTC 3950 Thermistor parameters- Small Size: 1.25mmx2.0mm glass bead- High accuracy: 1% - Resistance value at 25C=100K - Wiring insulation: high temperature teflon/PTFE- Wiring length: 1 meterPackage Including6 * Stainless updated barrel tube1 * 0.4mm brass nozzle1 * Aluminum updated heater block with necessary screws1 * 12V 40W Cartridge Heater Cable1 * NTC 3950 Pre-wired thermistor
A**R
They product works good and the seller support is great
They product works good and the seller support is great! The picture shows the barrel pre-installed but I had to install it and was not sure which end of the barrel went to the nozzle. I received a very quick response that the end with the tube flush at the barrel end goes to the nozzle. There is one other thing I had to do. The original printer thermistor had red/black leads for polarity and this one has 2 white wires. I just tried it one way with red/black and got an error max temp reached on the printer. Reversing the connections made it work.
N**7
Five Stars
Worked great on my Anet A8
Trustpilot
5 days ago
2 months ago
