Brushed Queen F3 Flight Controller with Built-in 8CH Frsky Compatible Receiver Fdti adapter for Tiny whoop Blade inductrix Carbon Fiber Quadcopter Frame Eachine E010 Mini Micro quad fpv racing

3d printed a tiny tie fighter and wanted a budget FC to put on it since I wouldn't really be flying it much, just fun as a nerdy way to show people the hobby.Anyway, got the FC bound it to my QX7, set it up and betaflight and it seemed to fly fine in LOS as I hadn't put a camera on it yet. At this point it seemed perfect!The following day I got out my stuff and wired in a camera (TX02 I think...) Anyway when I was done the board powered on, the camera was working find, but I wasn't getting any response from my Taranis. I hooked it up to Betaflight and on the Receiver tab I was getting no signal from the transmitter. I tried re-binding and no luck... maybe I wasn't holding the button long enough? I tried nearly everything. I worried I'd shorted something out wiring up the camera, but that didn't seem likely.As a last ditch effort before tossing the board and assuming I'd must have shorted something, I tried flashing the board. Well, I was back in business. Everything connected, however, It was flying like the battery was low so either I'd grabbed a near dead battery (very possible) or the PIDs were off. I grabbed another battery and.... it wouldn't connect to the Taranis again. I power cycled the board and the Taranis several times and all of a sudden it was working. Since then I've found it's sort of a crap shoot if this will connect to my transmitter or not I usually cycle it 5-10 times before it eventually works. Very annoying and to be honest, I'll probably never use it because of that. I have a spare Inductrix frame and I shoved it in there for now. I might continue to fiddle with it, but probably only if I get bored.

 in betaflight all of the motors seem to work fine when i use the master sliderbut when i use my taranis Q X7 radios throttle motor 3 jumps to 1500+ and tops out at 2000 and the other struggle to get to 1400i get these results with and with out the battery connectedthe quad is sitting on a level surfacethe quad flies to about 6 inches altitude but it has no power to climb and will fall out of the air at any timeas far as i know there is no calibration for brushed motor controllers

I got it to work but I am still working on tuning with a x7 taranis