ESI Ultimate Tailgate Seal with Taper Seal 6ft for Either The Sidewalls OR The Tailgate Bottom

Excellent product. Quality foam, so it keeps its shape and the adhesive is serious stuff. Take your time with a good install and you’re set. Vic went above and beyond to help me get the right size for a tricky project. This is the company to order from.

A relatively good product but I did run into a little bit of an issue during the installation. The instructions are fine but the illustrations are not very exact as to the placement of the product. I felt like I installed it exactly like it is pictured in the instructions but I ended up with a quarter inch gap between the weatherstrip and the tailgate. Once it’s stuck to the metal it doesn’t easily come off and it gets ruined taking it off. I did have a considerable amount left over on my Toyota Tacoma and I would suggest cutting off a short piece and testing the placement before you install the full length of the amount you need.

Instructions were fairly straightforward. Also used the manufacturer’s online instructions to insure proper installation. Overall good experience.

Not a great fit for a colorado. I only need it for the sides since I have a cover. Had to apply a small piece at the top to fill the gap. Likely not the fault of the seal just a weird tailgate on the Colorado's. Not sure how good it will stick. Fingers crossed.

Easy to install. It keeps the dust out of the back of my truck.

Installed this on the edge of the GMC truck bed instead of the tailgate. So far it is holding up fine. I previously installed a seal on tailgate and after a year or so of open/close of the tailgate the seal rolled completely off the tailgate.Update: This seal has been installed several months and it working perfectly. Much better than the type that mounts on the tailgate itself.

Needs to be a bit longer. Their was one 6’ and another 1’ that was thicker not sure why. But it does seal well

This product was easy enough to install. I followed the directions to make sure I had good adhesion but after about two weeks the weather stripping could not hold on any longer. I washed the bed with soap and water. I then used multiple alcohol wipes and used a 3M product that was designed to give even better adhesion to plastic. I had purchased a gap shield to help keep any dirt and debris from falling down onto the weather strip that could cause separation from the truck bed but, alas that is exactly what happened. Sand and dust were still able to get into the adhesive strip, causing it to release. Too bad. I had high hopes this time.