AUTOXBERT 38cm/15 Inch Hand Sewing Steering Wheel Cover Breathable Anti-Slip Leather Steering Wheel Cover for Nissan Qashqai Toyota Camry RAV4 VW Golf

my only complaint is i wish it came with extended leather bits for the 3 bars as seen in the photos. looks and feels great though, didn't take long to figure out how to stitch it. was kind of fun putting it on. would recommend

Great if you dont mind spending time on the stitching. I took a solid 30 minutes to do this. Im sure more experienced individuals could do it quicker but it is very tedious. The feel is great and its a decently grippy cover. The stiches make it alot more secure than the slip on covers.

Pros, the look and feel on the cover is great. Cons. The stitching in it appears to be an ok thread but could be stronger and it's NOT TIGHTLY SEWN ENOUGH IMO to actually use it to pull your stitching together to sew this cover over your steering wheel. This results in forcing you to sew through the faux leather, if you want to be sure it won't fall apart, which is immensely more challenging and time consuming! There is not enough thread in this kit so I bought some from Johann Fabrics and extra needles to do the job. So in closing remarks, the stitching of the cover needs to be tightened up, tighter and closer spacing and ideally strong threading. More thread in the kit as well. The cover itself feels and looks great. My two cents. ✌️

This was the best cover I found. I had been using a slip over type, but after just a few months it started cracking and it was also very fat. It took a little time to install this, but it was basically easy and it looks like it belongs in the car… not an afterthought. It’s also very soft and feels great in your hands. Simple and great product!

Only downfall is I didn't take into consideration the photos are apparently black and white pictures. It isn't dark grey like in main picture it is light grey for anyone else considering. Still looks and feels good I'm just imagining it getting dirty rather quickly so we shall see how it holds up constantly being cleaned.

Feels great and fits my nissan perfectly even with the flat bottom of the wheel.I have done one of these ages ago on my old car. I don't weave between the stitching. I loop back through the holes themselves.It seems too narrow at first but you have to tighten as you go. This took me like 2-3 hours in the dark after work. I definetly could do it in half the time it i ever did it again.

One side fit excellent with tight stitches, and the other side of the cover had less pleather material as it did not cover the circumference of the wheel as well and left wide stitches. Still works, but I’ll have to redo it soon.

Producto a la medida perfecta. 100% Recomendado

Lo ubiera conprado antes.

It was a real wrestle to get it on and took time to sew in properly. But was worth it. Looks and feels soooooo much better than a slip on cover.

This diy cover is really great so far feels, looks absolutely spot on.

The feel of the fabric is nice, I have a clio mk4 and this doesn't fit. The diameter is fine but the circumference is too small.There is also not enough thread with the product as I ran out before finishing, even if the circumference was large enough, its still not enough thread.Not very happy with the product as its now useless to me.

Came early , good quality, easy fit , used it on my bmw e34 perfect.Very happy with the results