10 Pack Basswood Sheet, 1/16 X 8 X 12 Inch Thin Plywood Wood Sheets for Crafts

I refinish dressers and this is great to repair any veneer damages. Easy to cut and thickness ia perfect.

These worked great for awards we made for our car show. I was able to cut the wood easily with my Cricut Maker using the knife blade. They were easy to paint and stain, just use light coats and don't get it too wet, it is thin wood and can warp easily. The vinyl stuck fine and I used DAP RapidFuse to gluse small blocks to raise up the smaller wood pieces. Will use again for other projects.

These are pretty reliable for laser cutting and engraving. I have not encountered any of the dreaded glue patches or filler, and the face of these is very good and generally free of blemishes. If they offered them in 30x30cm, I would certainly grab those instead, but these are great if the size limitation is not an issue. I am a repeat buyer.

Pros: The sheets look good.Quality of the two sides of the sheets is high.Very rigid; very light in weight.Cons: None at the moment.Comment: We will see how good they look once they acclimate to my shop !I hope they remain as flat as they are, I plan to weight them down until they have a chance to warm up a little.Fast Prime Delivery !Added - 04/11/21: Update !1) Although the sheets are not flat, there is very little bowing, once they are in use I believe they will retain flatness. (If you have left over sheets, place them in a protective wrap and put some weight on them, won't hurt) !2) Cutting - I was unsure how to cut the sheets.I didn't want any frayed or chipped edges but tried to cut the first sheet using a Backsaw, very fine teeth, but that chipped the lower layer before cutting though.I then used an Exacto Knife with a new blade... (very sharp) applying low pressure and making eight low pressure cuts, I was able to cut through the sheet and make a very fine cut with no chipping or fraying on either side.I lightly sanded the edges, watching out for the cross grain sanding, and ended up with a really nice piece of thin plywood that fit my purpose to a "T" !These panels are very thin and you will need to watch out for the sheet cracking while you are working on it (none of mine cracked but they were well supported) and DO NOT apply too much pressure when cutting; use a few extra low pressure cuts instead of one forceful cut, the results will pay off in the end.I hope this update helps someone, I almost lost the first sheet but with some light sanding I was able to recover the Backsaw Cut Sheet.Now for a little stain, some felt, and away we go !Thanks to the manufacturer, a great product you have made !

These sheets are very thin (1/16”) but very durable. I use them to woodburn panels and for painting. They don’t warp or buckle when painted. Good quality with nice wood grain that stain will pick up. Very little knots, if any.