2212 920kv Brushless Motor(CW/CCW)-4 Pcs For DJI Phantom F330 F450 F550 X525

I bought these as temporary replacement motors for a Phantom 2 vision. Well that was my intention. But after installing these I am very happy with both the performance and run time of the copter with these motors. I now have 7 hours on these motors and they sound just like new. For the price point I am very happy with the purchase.

Work well with lots of power. Some do need some balancing but not bad. One of the four motors wasn't working correctly and the company was quick to send a replacement at no additional cost. This was my second set of motors purchased from this company.

They are good. But 2 of them were broken. Got an instant refund from seller.Will re buy it.

The props Amazon recommends do not fit these motors. Do not buy:https://www.amazon.com/gp/product/B01CJMJ886/ref=oh_aui_detailpage_o03_s00?ie=UTF8&psc=1These motors have flat sides on the shafts and the props they suggest are round. I just ordered these in hope they will work:https://www.amazon.com/gp/product/B01NBMCGFN/ref=oh_aui_detailpage_o00_s00?ie=UTF8&psc=1

They work good.

Ordered and received these motors from Amazon very fast as always. However one motor will not work correctly. It looks like the other three but it won't start spinning until half throttle and never spins up to full speed like other three. I tried swapping the ESC's to make sure that wasn't the problem but the motor did the same thing. I then tried the other three motors with each ESC to test and they work correctly. Just this one motor won't work. Also when you hold the motor and slowly turn it by hand it doesn't have that solid thump thump thump feel like the other three motors. It just spins like there's no magnets or coils inside. I also tried going thru the instructions but there were none included in the shipment. Amazon refunded my purchase price so now I have wasted hours of searching for product and couple of weeks of not being able to use the product. Starting all over looking for good working motors. Also the propellers recommended from Amazon DO NOT FIT these motors, after searching for hours I finally found the right ones on Amazon from DJI. They are props for a Phantom 2 or early model 3. Not the later or current model Phantom 4 props. The props that correctly fit these motors from DJI cost a lot more but they are quality balanced props.So can anyone recommend a Good Quality 2212 or 2312 (800-1000kv or other size) Brushless motor for a F450 quad copter build using 3s LiPo's, SimonK ESC's and PixHawk Flight Controller???????

Real Owner, real user, real REVIEW I have 2 quads using these, on 450 frames with 10 inch props, and 4 power.. Excellent motors!

Seems to be operating fine in the few weeks I've been using it. I needed to replace only a single motor but wasn't sure if these would be the exact match I needed But the price on this four pack was so good I took the risk and so far I'm glad I did.

They're on a 450 size quad and are being driven with 32 bit ESCs running DShot. I am able to get 10 minute flights using only a 1300 Mah battery. They're quiet, smooth and seem to be efficient. Unlike some other reviews, all 4 of mine workED well right out of the box.

I cuscinetti sono leggermente rumorosi, ma comunque nella norma.Sostituiscono egregiamente gli originali DJI e sul banco di prova della Turnigy, danno i medesimi risultati.Se state allestendo un quadricottero partendo da 0, consiglio di acquistare degli ESC con firmware Simonk, in quanto sfruttano questi motori al meglio.