J-B WeldWaterWeld Epoxy Putty Stick Off White, 2 oz. 1 Pack, 8277

A+ quality

Does the job 👍

Hello, I have purchased from your store But unfortunately the adhesive does not work well, I think it has been a long time since its production Half of it has dried up and no longer works properly Please do not sell items that have been in production for a long time I lost my money without interest

Good

I wish I could give this 6 stars. I had a small but annoying drip coming from my cast iron plumbing which is now over 50 years old. This was easy to apply. Just break off a small piece and knead. It sticks directly and cures very fast. Just spread it over the leaking area. So far it has been a few weeks and the leak is still dry. I see this as a permanent fix that will last a very long time. There is a slight odor but it goes away as it cures. The repair is not attractive to look at. Maybe a more seasoned veteran could make it look better but it is on a pipe in my basement and saved me hundreds.

Ich habe den J-B WaterWeld Epoxyd-Kitt für meine Pool-Filteranlage benutzt, weil am Deckel ein Riss war und ständig Wasser austrat. Obwohl die Anleitung nicht auf Deutsch ist, war die Anwendung absolut selbsterklärend: Stück abschneiden, kneten, auftragen – fertig. Meine Erfahrung: Sehr einfache Anwendung, man braucht kein Vorwissen. Nach dem Aushärten absolut dicht – 100 % erfüllt, was ich mir erhofft habe. Ideal für Notfälle im Pool- oder Sanitärbereich. Wichtig zu wissen: Das Ergebnis sieht nicht unbedingt schön aus, eher wie ein grober Flicken. Wer Wert auf Optik legt, sollte das bedenken. Handschuhe sind Pflicht – das Material klebt stark und ist schwer von den Händen zu bekommen. Fazit: Der Kitt macht genau das, was er soll: abdichten. Für mich hat er ein teures Ersatzteil gespart. Klare Empfehlung für alle, die schnell und zuverlässig etwas reparieren wollen.

I used this on my stainless steel hot water cylinder 2 months ago as a temporary fix and so far so good is still holding. My cylinder is a on a sealed system with 2 bar pressure. I discovered a leak in good time before any damage to my timber floors. Waiting for a plumber just took too long and so I decided to do a temporary repair myself. I located a pinhole leak which was squirting the water out a distance under pressure. The foam insulation around the tank meant I had to do a bit of insulation removal to find the leak location. I drained the cylinder tank, dried around the area and used the JB Waterweld to repair the hole. I used latex gloves which, while very sticky with the epoxy putty, is better than bare hands with sweat/hand moisture etc which I felt could prevent the epoxy from adhering properly. I used about half the epoxy putty and worked it into the pinhole as much as was possible and then covered a big patch around the area but not too thick. I tried to remove a small bit of the dried epoxy putty recently to see how well it was sticking but it was completely ’welded’ to the tank. Obviously the most important thing is to make sure that both parts of the putty is completely mixed together to form the off white colour before use. I probably will need to get a new cylinder tank in the near future but everything is back working ok at the moment.

Works as advertised. Easy to use and waterproof.