The primary advantage of using the connectors is to greatly enhance the connection time with all telescope accessories preventing cross-threading and expensive damage to the telescope's rear cell and/or accessories. The connection time it takes is fractional to conventional threaded method. Also the Quick-connectors do not lock up when temperature changes like threaded connectors do. All Quick-connectors are made with high-grade anodized aluminum and uses a 34 lb. compression four point steel wave spring, that is design to hold up to the some of the most complex configurations. Comes with a flexure chart. There are two main components used, (1) A Unit (attaches to the telescope), (1) B Unit for the accessory to be mated to the telescope. Each and every telescope accessory uses a B Unit, The A and B Units are all installed one time and need not be removed. See Figure 1 The conventional method consists of screwing the fine threaded ring of all accessories available for the telescopes on the 2" threaded back of the rear cell of the telescope. This can be some what difficult in the dark and to those who are not familiar with the task. the conventional method takes an average 10 to 12 seconds to install and 7 to 8 seconds to remove. The Quick-Connect system takes about 2 seconds to install and one second to remove an accessory, This is a plus for astrophotography applications! Below are a few examples of accessory attachments using the Quick-Connect system. Originally designed for Alt-Az applications, This works well with basic accessory lengths to achieve maximum fork clearance, It is highly recommended to use an equatorial mount for more complex applications, such as CCD imaging, focal reducers, moto-fopcusers, etc.
Trustpilot
2 months ago
1 day ago
