PRO-1 HOT KNIFE, Electric Heavy Duty Foam Cutter and Wax Cutter

When i received my hot knife, I plugged it in and it went out within 2 minutes. It never worked again. I sent it back and received another one. I was able to use it for about 5 minutes. It then cut off and never came back on. I am going to send it back again.The company I purchased it from was very nice and did send me a new one. I hope they will do the same again. I may just ask for my money back and try one from another company.

I thought I would spend more to get a quality product and I purchase this (Pro-1) Hot Knife and it is only 6 months old and it is already dead. It had very light use. I would say it probably had one hour of total use. Don't waste your money on this product.

I used it to burn lines in my stryofoam basement walls for electric wire, it took along time to burn a groove 7 foot long by 2 inch gap for the wire. The handle broke before I was half way done using it. I had to take it to a welder and have it spot welded back together

I work at a high school that goes ALL OUT for Spirit Week decorations, and most of them are made of 1- to 2-inch styrofoam. This cutter was indespensible as we sliced our way through sheet after sheet (after sheet after sheet!) of styrofoam. It is worth every penny if you have cut lots of styrofoam. However, it's important to keep in mind that melting styrofoam gives off noxious fumes, so it's vital to work in an extremely well ventilated area!

Sorry but lasted about 30 minutes on ICF wall and crapped out. Sawzall worked tons better than this for cutting ICF walls.

Wow this has made my life a lot better, why did I wait so long to get my pro 1 hot knife

Worked for maybe ten minutes, tops. Only reason it got one star is that there are not any negative-star options.

I bought one of these to cut grooves in my ICF (Insulating Concrete Forms) basement for electric wires and outlet boxes. I did a total of about 7 drops and boxes and had no issues at all with the tool.Works great for this type of work and was much easier then trying to cut out the channels by hand (plus it was very messy trying to cut it). Pretty solid tool.