FLEXIMOUNTS for 3 LCD Screens Computer Monitor Mount (D1T)

I have this mount on my desk for 7 weeks. My monitors started tilting forward slowly around week 2. I thought maybe I didn't tighten the clamp enough, but it was as tight as it can get. Regardless, I placed boxes to support the monitors while I loosen the clamp to straighten the mount and tighten it again. 2 weeks went by, it started tilting again. Instead of straighten it, I just angle my monitors higher because I did not want to go through the trouble again. Fast forward to yesterday, it tilted over 2 inches forward. I had to take it all apart because it was tilted too much forward for me to adjust it without the mount falling forward with all the monitors. I wasted 30 minutes taking it apart and putting it back together. Will be looking for a monitor mount with a stand WHEN it starts tilting forward again.My setup: I have 22"(left), 27"(center), and 19"(right). I can adjust the 22" to my viewing angle with no problem, however, I do not think you can mount 3x 27" with much adjusting room.

This absolutely mount sucks.While the design is simple and feels sturdy, it simply can't handle LCD monitors. Maybe LEDs would work better.The tilt bracket screws are too small and rely on a small washer to have grip. It just doesn't work, you have to tighten the f*&k out of it which there's very little room to work and the included hex tool doesn't have the leverage. I spent a good hour working on it and I could prevent my 24" from tilting. I now have a small speaker at the front supporting the screen.Amazingly however the left and right wings have no problem.

Decent mount but there's a noticeable difference in the height that the left and right monitors sit at. All 3 monitors are identical but for some reason there's an inch height difference between them and the middle monitor. It's kind of frustrating and I can't tell if it's a defect or just a really poor design choice.

For the price this mount is hard to beat.Pros - Instructions are excellent. Everything was numbered and marked. Printed material was easy to follow, and really helped with the installation.Cons - Doesn't feel the most sturdy. However, for the price this is more than sufficient.

It does the job well - not as well as the arms I see used at my work, but I imagine those are also significantly more expensive. It's reasonably sturdy, though I question whether the small screw + tension that actually holds the arms aloft will remain in place over time. It's been a couple of months though, so it's a case of "so far, so good."

For the price the quality was much better than expected. My colleges have two monitor mounts that are much lower in quality but are two thirds the price of my 3 monitor mount. I recommend this specific mount to my friends.

Assembling it, took a little extra work one of the tighten screws was missing and I had to get an extra one. It works fine and I recommend it.

I got 3 27" monitors and the stand sags a lot. Middle monitor is 1" to 1.5" higher then the ones on the side. My monitor weigh little less then 15lbs each. I would not buy this product if you want all your monitors to be even.

Lo único malo de este soporte es que luego de unos 3 meses, como que los tornillos del brazo se "cansan" y las pantallas se empiezan a inclinar, tienes que volver a ajustar y atornillar para que se detengan, creo que ese sería mi único punto malo, pero dado que el precio fue muchas veces más barato que otros, no me parece tan malo.