MOTOALL 2 Pin Ignition Coil Connector Case For Toyota 1JZ 2JZ 1JZ GTE 2JZ GTE for Lexus SC300 for Mazda RX7 S6/7/8 7283-8226-30 by Atomic Market

I was able to use these to replace the VVT valves connector shells on my Volvo XC90 B8444s engine that had cracked and disintegrated internally due to heat damage. I removed the wires and pins from the new connectors and inserted the factory harness wires & pins into the replacements.

I used these to repair the variable valve timing sensors on my 2006 Volvo XC90 with the V8. They were a perfect fit.Note: I actually was able to remove the pins and use the plastic from these sensors.These are MUCH cheaper than the equivalent part when you buy it for a Volvo.

I used it to replace broken ignition coil connectors , i did not use the wire that came with them because the wires were ok in the engine harness , just remove wire and installed on vehicle , working ok so far i installed them last month

I don’t write reviews often, but these things are phenomenal. They were easy to unpin from the pigtails and went right onto my factory harness terminals and plugged in as good as factory. And the price is next to nothing. Even if they only last until next plug change, they are well worth it.

Figured out how to disassemble using a small pick. Replaced all 3 on my 4runner without having to splice into existing wiring. 30 minute job. Quality is very good.