VP Flexible Skirting Trim - PVC Self Adhesive Skirting Board - Black - 52mm x 15m

Used for beading load of rubbish

Rubbish... Coiled plastic trim never straightens properly after uncoiling....Adhesive. ?? Tried to stick on new wood floor but because of it being coiled it springing back Dont waste your money..

The sticky back is not sticky at all. Otherwise, looks okay.

15m Roll - was wide enough to cover the variable gaps ( not perpendicular walls! ) Was quite tought to bend into angle but a good firm pressure sorts it! Tho slight word of warning - bending too much causes stress along the crease and couple of times it ripped along the crease . Adhesion was excellent- almost too good ( make sure surfaces are clean , free of dust , grease etc) - but caveat is the adhesive strip doesnt reach the edges so need to make sure the strip is stretched to the max before pressing for adhesion- the material is thick enough to hold it straight against the wall. Overall very pleased with result but I suggest work out a working technique with a few short trial & error runs. Mine was to press the edging strip into shape tight against the wall first & then only removing the backing paper from one the sides ,(decide which side you want to stick down first - mine was the floor half ) as you slide along in short distances. Then when done the length then remove the backing paper from & stick down the other side. This technique worked really well.

Very good quality

Bought it to cover up some rough edges on polystyrene ceiling tiles. Seemed to be cheaper option than half round self adhesive stuff which I would have preferred look wise. Basically in places it is not sticking well and will have to redo with some proper glue. The glue is a bit puny. At first I thought that when it was stuck that would be it for my ceiling tiles and if I wanted to take it off it would be wrecking them. No worries there because it's parting company. Yes I know it's for wall/floor but from what I can see the same thing will happen. Would not recommend. 2 stars.

rubbish!!! looks ok after fitting but four months later lost adhesion and fell off the wall

Worked well for mw BUT I had the sense to reinforce with stong adhesive floor spray. Wasn't an expensive extra and one canister lasts.Take your time, pre bend it and spray the surface you want to attach it too. Press along and apply pressure for good result