KEMIKO NEUTRA CLEAN is an industrial strength, low VOC, high performance water base sodium metasilicate cleaner for the preparation of bare concrete and coated substrates. KEMIKO® NEUTRA CLEAN is a water viscosity, single component product with a pleasant citrus odor that does not contain any hazardous solvents, is concentrated and diluted with water, and prepares the surface for staining, sealing and re-coating. Applications: KEMIKO® NEUTRA CLEAN is typically applied to concrete substrates to remove deleterious matter such as grease, grime, soil, wall plaster, and other construction related residue. KEMIKO® NEUTRA CLEAN is applied with commercially available pressure sprayers, steam cleaners, or simply poured onto floor and worked into the surface with a stiff bristle brush or floor machine. Typical applications include commercial kitchens, grocery stores, restaurants, showroom floors, walkways, and many other interior and exterior surfaces requiring cleaning. Surface Preparation Bare Concrete: Use KEMIKO® NEUTRA CLEAN to remove visible oil, grease, sludge, stain residue and any other contaminants that may impact a Kemiko, Rembrandt or Sta-Crete product application. Apply Kemiko® Neutra Clean to substrate, allow 2-3 minutes to "wet in" then scrub using stiff bristle brooms, brushes or heavy duty fl oor scrubbing machines. DO NOT ALLOW KEMIKO® NEUTRA CLEAN TO DRY ON SURFACE. Once the scrubbing action is completed, rinse surface with clean fresh water. Check surface again to insure all deleterious matter is removed. Repeat application of KEMIKO® NEUTRA CLEAN if necessary. Surface shall be allowed to dry thoroughly prior to any staining, sealing or coating application. Existing Coatings/Sealers: Apply small amount of KEMIKO® NEUTRA CLEAN on surface, allow to stand 5-10 minutes and rinse with fresh water. If existing coating or sealer is not affected (removed) by Kemiko® Neutra Clean, proceed as instructed above for surface preparation.
Trustpilot
1 month ago
4 days ago
