EWK 14mm 12-Point Thin Wall Magnetic Spark Plug Socket

Socket is well made, feels good in the hand and the magnetic portion grips the plug well enough to allow you to remove and reinstall it deep down in the head without fear of dropping the plug, but not so much that sticks to the plug and disconnects from the extension when you're done tightening and withdrawing it from the hole. Used on a 2010 Mini Cooper R55.

Great tool for replacing the plugs on my 2013 Mini Cooper. Magnet was more than strong enough to securely remove and replace the spark plugs. Made the job a breeze. Due to engine design my standard socket would not fit into the tight/small inside diameter access of the tubes plus the magnetic design removed all concerns of dropping or cross-threading the new plugs. Great investment for the DIY guy and the professional alike.

Fits 2017 Mini Cooper S. This tool did the job without issues

Worked great for 2014 335i

I bought this because I didn't have a 14mm spark plug socket and I needed to replace plugs in my wife's car. I like the magnetic spark plug sockets because they hold the plug without using the rubber insert. The problem with the rubber insert is that it gets oil and dirt on it and dries out over time. Eventually the rubber falls right out. (or sticks to a plug when you pull the socket out) I have even had the rubber part stick to a plug on the first use. (cheap sockets) The magnetic sockets are better but the downside is that small pieces of metal stick to the magnet. It is difficult to get the metal pieces out but it can be done. The best bet is to keep it in storage when not in use. (keep it away from the ground when you are cutting metal for example and keep it out of dirty toolboxes which tend to get metal filings or rust in them over time) There isn't a whole lot else to say about the socket. The sidewalls were relatively thin so it worked on the Altima. I now have one more size spark plug socket in my collection. One note on the iradium plugs though, don't drop them. They aren't meant to be gapped. Get the right gap plug when you buy it. I dropped an old plug after I was done and the gap was way off due to the drop. If I had dropped a new plug I would have had to buy a replacement.

Great deal

Worked like a charm ;)

works great on tight plug holes like on mini coopers

Perfect for my BMW N54 engine spark plugs. Magnet is strong enough to hold them on removal.

I used them last week for a 10th Gen Honda Civic and they worked. Had to spray a touch of penetrating oil and drive the car around to warm the plug up before they came out, but they came out and the magnet bit held the plugs in place when I lifted them out.

Used to change spark plugs on a N55 engine. Worked flawlessly. Highly recommend.

Exactly what was needed for a Mini Copper spark plug.

Perfect fit on bihex 14mm spark plugs. Magnetic and thin walled. Perfect for my Mini.