Size: 240 mm, Round. Use with 250170 mm Borosilicate Glass. Voltage: 24. Watts: ~200. Resistance: ~2.4 ohms. (Resistance was measured at room temperature.) Heater Specifications: Lead Length: 1000 mm. Lead Wire: High Temperature Teflon. Lead Location: Center. 1 cm Hole in Center. Adhesive on Back. Thermistor Specifications: Location: Center. 100K Thermistor +/ 1 percent. B = 3950K. Operating Temp Range -35° C to 300° C
J**R
Perfect for upgrading my Rostock MAX 3d printer to 24v
Recently I updated my rostock printer controller to a duetwifi3d. This controller is fantastic but it only supports 1 primary voltage so you must make some decisions. I decided that I needed 24v but the original bed heater would draw more current that the duet could support on 24v so enter this kapton bed heater. I stuck this heater to the bottom of my cast aluminum build plate and it heats up just fine and allows the full current supported by the duet to be applied to the heater.
Trustpilot
3 weeks ago
3 weeks ago
