Snail car horn

I bought this set to replace the factory moped horn in my 2008 Mazda MX5 (Miata). The enclosed mounting brackets, hardware and connecting wires were perfect for making the installation easy. I am THRILLED with the loud but pleasant-sounding dual-tones and the horns are a huge improvement over the single factory horn. Other cars and people can actually hear me now when I need to be noticed! I highly recommend this set and would definitely buy it again! Small note: the first set I ordered was missing all the hardware, be sure to check immediately upon receipt.

I installed this pair of horns on my 2013 BMW R1200RT to replace the embarrassing stock horn. Since the stock horn circuit is rated at 6A, and these draw about 6A each, I purchased a relay kit (available on Amazon) and ran them from the "load" side of the relay. The result is a crisp, loud horn that sounds like a car, which was the whole idea. It's true that there are "air horn" options that might be even louder, but this is as loud as any car and available at a reasonable price. I'm glad I bought these.

Very loud

These are as loud as the OEM horns and go in easily. They are compact, too. I used weatherproof connectors but the spade connectors would last a while. Be aware of the electrical polarity when installing and you will have no problems with these.

Put these on my motorcycle, Suzuki Hayabusa. It's a tight fit and required some mounting trickery but are in roughly the same place as the OE horn. Have to split the wires to accommodate for there being 2 horns: high and low tones, but not too difficult. The high tone is coming on intermittently but I may have a loose wire. Wish the mounting brackets provided had been stiffer.

Yes they are easy to install and am not sure about them being waterproof but certainly don't sound as lous as they say they do.

Perfect replacement for my RAV4 with the standard laughable sound.

I bought these to replace 2 dead horns in a 57 year old muscle car. They look very similar to the OEM parts. I could not justify $200 for OEM parts so I bought these. They work great. One is high pitch the other is low pitch. worked perfect.

Remplacement parfait! Plus puissant que celui d’origine.

Stud bolts are too short for any gromet mount application (as was the case for my FJR - I only replaced one of the two because of it). They really should be at least another 1/4-1/2 inch. Very good upgrade otherwise.

utiliser pour remplacer un klaxon unique,environ la moitiée des décibels entendu.