Wolfride Rabbet Router Bit Bearings Replacement Bearings for Router Bits | Inner Dia. 3/16” & Outer Dia. 3/8", 1/2", 5/8", 3/4", 7/8", 1", 1-1/8"

I mounted this horizontally on some shelving next to my bench grinder. I just drilled a hole slightly smaller than the shaft and then hammered it in. I use it to balance lawn mower blades while sharpening them. It just happens to have a bearing that fits the center hole on my Craftsman lawnmower perfectly. I trust this way more than those cheap balancers that have the blade rest flat on top of it. Those you have to eye ball level. They're probably good enough, but this thing doesn't leave much room for error. Either it rotates left or right and needs more metal removed, or it doesn't rotate and it's balanced. I got the idea from seeing those ridiculously expensive wall mounted balancers and then going on youtube to see if there was a DIY version. Sure enough, some guy had a video using this item. I'm sure you could fabricate some sort of magnet to keep the blade from falling off like the expensive ones, but I've never had my blade fall off. The bearings are wide enough that the entire width of the blade is in contact with it. I only put it up there for a couple seconds, take it off and grind and then re-check until it doesn't move. The blade is never left there where it could be accidentally bumped off, I don't have anything I care about under it and I keep my hands close so i can grab it in the center, if for some reason it did pop off. Those magnets are pretty cool though. ;) Hope that helps you.

They fit Freud, Bosch, Craftsman. They allowed more precise depth control of the rabbets

Excellent product

These perform well enough for me. I use them for routing binding channel for guitars where even little mistakes are not acceptable. They work in that situation just fine.

Works well

This router bearing set seems to be very good quality. The individual bearings spin easily and smoothly. There are also several extra retainer screws included. An added positive is that all of this router bearing set fits together on one spindle, promoting loss of individual bearings. My recommendation is a positive yes, I approve of this set.

One of the bearings came apart on the first use. I haven’t used any of them since.

for a "mower blade balancer" I added a 5mmID x 1mm thick washer between each bearing on the 3/16" shaft because as-shipped the bearings stick together somewhat, causing the whole 'gang' to rotate rather than just the bearing the mower blade hangs on. because the increased thickness of the added washers (5 total), I had to leave off 1 bearing.